Filter
Top Products
13 TD-EX90
To let recording pause temporarily:
Press REC PAUSE. The tape indicator stops blinking and
lights steadily.
Press ¤ or ‹ to resume recording.
To record continuously on both sides of tape:
1 Load a tape so that you can start recording from the
£ direction.
2 Press REVERSE MODE to switch the reverse mode
on.
Press so that the reverse mode indicator (π) lights up.
3 Prepare recording of the associated components.
4 Press REC PAUSE.
5 Press ‹ to start recording.
• The recording in the reverse mode stops after
completing recording in the ™ direction. Be sure to
start recording from the £ direction.
• When the reverse mode is switched off, recording
stops after having recorded onto one side of tape.
Note: The side erasure tab is removed (refer to P.19)
will not be recorded even though the reverse
mode is swithed on.
To record audio using Dolby NR
The Dolby NR is used to record audio to reduce hiss noise
when the tape is played back later. The Dolby NR includes
type B for popular use and type C for even improved noise
reduction effect.
Press DOLBY NR so that either the B or C indicator lights
up.
• A tape recorded using Dolby NR should be played
back using the Dolby NR of the same type as that
used in recording. The audio quality will be affected if
a different type is used in playback.
DOLBY B NR
(Indicator lit)
Off (Canceled)
DOLBY C NR
(Indicator lit)
1-23.TD-EX90[J]/1 5/12 98.6.4, 11:59 AM13