Filter
Top Products
12 TD-EX90
Recording
Tape recording (Basic operation)
Three tape types including normal (Type I), High position (Type II) and Metal (Type IV) tapes can be
recorded onto. The type of tape is identified automatically by the cassette deck.
1 Load the tape for use in recording, with the
side A facing up.
Press 0 to open the tape tray, place a tape on it and
press 0 to close it.
• It is not possible to record onto a cassette tape with
the broken accidental erasure tab. Use a cassette the
tab of which is not broken.
2 Prepare the recording source (Tuner, CD or
MD, etc.).
• To record radio broadcast, receive a station with the
tuner.
• To record CDs, load the desired CDs and program
tracks if required.
• To record an MD, load the desired MD and program
tracks if required.
• To record a component connected to AUX, prepare it
as required.
* Refer to the instruction manual of the source
component for its operating procedure.
3 Select the recording source with the
amplifier’s input selector.
4 Press REC PAUSE.
The REC indicator lights in red to indicate record-pause
mode.
5 Start playing the source component.
If you want to record CD or MD tracks from the first
track, first perform step 6 below (i.e. start recording)
then start playing the source.
6 Press ¤ or ‹.
• Pressing ‹ starts recoding on side A (top side).
• Pressing ¤ starts recoding on side B (bottom side).
The tape indicator starts blinking to indicate that the
recording is under way.
• The recording level is set automatically.
• Press 7 to stop recording.
• Press 0 to eject the tape.
CD RECREC PAUSE
1-23.TD-EX90[J]/1 5/12 98.6.4, 11:59 AM12