Filter
Top Products
EN
23
VIDEO (MONO)L—AUDIO—R
S VIDEO
A.DUB
DIGITAL TBC/NR
FF
REW
POWER
SPEP
VCR
REC PAUSE STOP/EJECT
PLAY
–
+
CH– /+
PUSH / TURN
INSERT
24HR QUICK
PROGRAM
REC LINK
Using two sets of SR-V10U, you can play back two
cassettes alternately as many times as you want. You can
select the returning point for Series Playback (੬ pg. 41)
Use the buttons and controls on the VCR’s front
panel for the Series Playback operations (except
when using Mode Lock).
1
Make connections
Connect two sets of SR-V10U and a TV using AV
cables as shown in the illustration on page 22.
● The mini-plug cable is a mono 3.5 mm mini-
plug to mono 3.5 mm mini-plug connector.
● When playing back S-VHS recordings, it is
recommended to use the S-VIDEO connection
to minimize picture degradation.
2
Turn on all components
After completing the connections, turn on all the
components.
● Set the TV to video input mode or A/V input
mode. Refer to the TV instruction manual.
3
Load cassettes
Insert the playback cassette into each SR-V10U.
● Set SR-V10U-2 to “AUX”. Press CH + or – to
select the input mode depending on the
connector being used -”L-1” for the rear
AUDIO/VIDEO IN connector, or “F-1” for the
front AUDIO/VIDEO input connector.
4
Start playback
Press PLAY ( 3 ) on either of SR-V10U. When the
playback reaches to the returning point (tape end
or recording end ੬ pg. 41), the other SR-V10U
successively starts to play. (The cassette will
automatically be rewound when the playback
stops.) Therefore, the cassettes loaded on two SR-
V10U will be played back alternately as many
times as you want.
To stop playback
Press STOP/EJECT ( 7 / 0 ) on the SR-V10U which is
playing back a cassette.
STOP/EJECT
( 7 / 0 )
NOTE:
If there is a power outage during Series Playback, the playback
will resume automatically when the power is restored to the
VCR. (No setting is required for this function.)
To prohibit operations during Series Playback (Mode
Lock)
Press and hold OK on the Remote for more than 5
seconds. "
"
and " "
light up on the front display panel
(੬ pg. 60). The 2 cassettes will be played back
alternately without any interruption.
To resume the other operations, press and hold OK on
the Remote again for more than 5 seconds.
● When OK is pressed to set Mode Lock, the on-screen
display appears and the time counter remains on the
TV screen. If the time counter is not necessary, set "ON
SCREEN (PLAY)" to "OFF" ( ੬ pg. 37, 39).
2
4