Filter
Top Products
9
For TV and video format
• When the TV is equipped with the multiple SCART terminals, refer
to the TV manual to check the available video signals for each
terminal, then connect SCART cable correctly.
• This receiver cannot convert the video signals (S-video or
Composite). When the video signal of one video component is
different from that of the other (for example, one is S-video, the
other is Composite), you may not see the pictures appropriately. In
this case, unify the video signals of all the video components into
S-video or Composite, or you need to switch the video signal of TV
each time you change the source.
For T-V LINK
• You can use the T-V LINK function if you connect a T-V LINK
compatible TV and VR to this receiver with a fully wired SCART
cables. For details on T-V LINK, refer also to the manuals supplied
with the TV and the VR.
• Connect a SCART cable to EXT-2 terminal on your JVC’s T-V LINK
compatible TV for the T-V LINK function.
• Some TV, VR, STB and DVD players support the data
communication like T-V LINK. For complete details, refer also to the
manuals supplied with these components.
SCART Terminal Specifications
TV VR STB DVD
AUDIO L/R ⅜⅜⅜⅜
IN
Composite
⅜⅜⅜⅜
VIDEO S-video − ⅜⅜⅜
RGB − ⅜⅜⅜
AUDIO L/R ⅜*1 ⅜*1
OUT
Composite
⅜*1*2 ⅜*1*2
VIDEO S-video ⅜*2 −
RGB ⅜*2 −
T-V LINK ⅜*3 ⅜*3 ⅜*3 ⅜*3
*1 The signals input from a SCART terminal cannot be output
through the same SCART terminal.
*2 The video format of the output video signals are consistent with
that of the input video signals. For example, if S-video signals
are input to this receiver, no signals other than S-video signals
can be output from this receiver.
Refer to the manuals supplied with the video components to
check the setting of the input/output video signals.
*3 The signals for the T-V LINK function are always going through
the receiver.
Getting started
01-10_RX-ES9SL[B]f 03.6.27, 16:459