JVC RX-7022RSL Stereo Receiver User Manual


 
16
NO for the subwoofer, LARGE for the front speakers,
and SMALL for the center and rear speakers are initial
settings. To get best possible sound, change the subwoofer and
speaker settings to fit your listening conditions.
Setting the Speaker Information
To obtain the best possible sound or effect from Surround modes
(see pages 29 31), register the following speakers and subwoofer
information after all connections are completed.
The followings are items you can set:
Subwoofer informationSUBWOOFER
Speaker sizeFRNT SP, CNTR SP, REAR SP
Speaker distanceUNIT, FRNT DIS, CNTR DIS, REAR DIS
Crossover frequencyCROSS
Low frequency effect attenuatorLFE ATT
Dynamic range compressionD. COMP
Before you start, remember....
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1
again.
Subwoofer information
Register whether you have connected a subwoofer or not.
1
Press SETTING repeatedly until
SUBWOOFER (with the current
setting)* appears on the display.
* NO is the initial setting. If you have already changed the
setting, YES will be shown.
2
Press CONTROL UP 5/DOWN to
register whether you have connected
a subwoofer or not.
Each time you press the button, the subwoofer
setting alternates between YES and NO.
YES : Select this when you have connected a subwoofer.
You can adjust the subwoofer output level
(see page 20).
NO : Select this when you have not connected or have
disconnected a subwoofer.
L C
S.WFR
CH-
LFE
SPK
DIGITAL AUTO
LINEAR PCM
1
R
ST SETTING
Speaker size
Register the sizes of all the connected speakers.
When you change your speakers, register the information about
the speakers again.
1
Press SETTING repeatedly until
FRNT SP (Front Speaker), CNTR
SP (Center Speaker) or REAR SP
(Rear Speaker) (with the current setting)*
appears on the display.
* LARGE is the initial setting for the front speakers and
SMALL is for the center and rear speakers. If you have
already changed the setting, another size will be shown.
2
Press CONTROL UP 5/DOWN to
select the appropriate item about the
speaker selected in the above step.
Each time you press the button, the display
changes as follows:
LARGE : Select this when the speaker size is relatively large.
(See Notes on the below.)
SMALL : Select this when the speaker size is relatively small.
(See Notes on the below.)
NONE : Select this when you have not connected a speaker.
(Not selectable for the front speakers)
3
Repeat steps
1
and
2
to select the appropriate
items for other speakers.
Notes:
Keep the following comment in mind as reference when adjusting.
If the size of the cone speaker unit built in your speaker is greater
than 12 cm (4
3
/
4
inches), select LARGE, and if it is smaller than
12 cm (4
3
/
4
inches), select SMALL.
If you have selected NO for the subwoofer setting, you can only
select LARGE for the front speaker setting.
If you have selected SMALL for the front speaker setting, you
cannot select LARGE for the center and rear speaker settings.
L C
S.WFR
LS RS
CH-
S
LFE
SPK
DIGITAL AUTO
LINEAR PCM
1
R
CONTROL
DOWN UP
LARGE
SMALL
NONE
ST SETTING
Basic Settings
Remote
NOT
CONTROL
DOWN UP
EN10-25.RX-7022R[B] 02.1.22, 11:01 AM16