Filter
Top Products
Page 10
English
Video component connections
To video output
Video disc player
TV
To audio output
VCR
To video input
Connecting the Power Cord
Before plugging the receiver into an AC outlet, make sure that all connections have been made.
1. Plug the power cord into an AC outlet.
2. Press POWER to set it in the
__
__
_ON position.
The STANDBY lamp lights up. A small amount of power is always consumed.
To shut off the power completely
Press POWER to set it in the —OFF position.
Keep the power cord away from the connecting cables for the TV, VCR, and antenna. The power cord may
cause noise or screen interference. We recommend that you use a coaxial cable to connect the antenna, since
it is well-shielded against interference.
The difference between the POWER switch and the STANDBY/ON button
• The POWER switch is the mains supply switch, allowing the receiver to connect to the mains supply.
To shut off the power completely, press the POWER switch to set it in the —OFF position.
• The STANDBY/ON button is a functional on/off (standby) switch, and does not disconnect the
receiver from the mains supply. A small amount of power is consumed even in standby mode for the
receiver to accept signals from the remote control.
Note:
A preset settings such as preset channels and sound adjustments may be erased in the following cases:
• When you press POWER to set it in the
—
OFF position.
• When you unplug the power cord.
• When a power failure occurs.
CAUTIONS:
• Do not touch the power cord with wet hands.
• Do not pull on the power cord to unplug the cord. When unplugging the cord, always grasp
the plug so as not to damage the cord.
POWER
_ON —OFF
GND
RIGHT LEFT
VCR
IN
(PLAY)
OUT
(REC)
CD
PHONO
AUDIO
TAPE
IN
(PLAY)
OUT
(REC)
VCR
OUT
(REC)
IN
(PLAY)
VIDEO
MONITOR
OUT
VIDEO
VIDEO
TV
SOUND
VHS
To audio output
To video output
To audio input
To audio output
To video input
RX-630RBK[EF]0055-001A.En.01-27 97.7.25, 5:23 PM10