Filter
Top Products
26
Make sure that you have set the speaker information correctly (see pages 15 and 16).
• If only the front speakers are connected, you cannot use Surround/DSP modes.
• You cannot use DSP modes if no surround speakers are connected.
• Do not change the speaker setting while using any Surround/DSP modes; otherwise, the Surround/DSP modes may be
canceled when you deactivate the speakers required for the Surround/DSP modes.
RX-6030VBK and RX-6032VSL only:
• When DVD MULTI is selected as the source, you cannot use Surround/DSP modes (SURROUND and DSP buttons do not
work).
Using Surround Modes
Speaker layouts required for Surround modes are as follows:
• 5 channels
(Front, center, and surround speakers
are connected.)
• 4 channels
(Front and surround speakers are
connected.)
• 3 channels
(Front and center speakers are
connected.)
Creating Realistic Sound Fields
7 Operating procedure
1
Select the source you want to listen to and
start playing.
• When playing back software encoded with Dolby Digital
and DTS Digital Surround, select the digital input mode
(see page 17).
SURROUND/DSP
OFF
DSP
SURROUND/DSP OFF
SURROUNDDSP
DIGITAL AUTO SPK
ONE TOUCH OPERATION
BASS BOOST
PRO LOGICDSPH.PHONEAUTO MUTINGTUNEDSTEREOTANEWSINFO
VOLUME
INPUT ATT EON RDS SLEEP
CH–
12
ANALOG
L
LINEAR PCM
DIGITAL
CR
S.WFRLFE
LS RSS
STANDBY
STANDBY/ON
PHONES
DIGITAL
PRO LOGIC
DIGITAL
SURROUND
SURROUND
DSP
DVD MULTI
SPEAKERS
ON/OFF
SUBWOOFER OUT FM MODE MEMORY
ON/OFF
FM/AM TUNING
DVD VCR CD FM AMTAPE/CDRTV SOUND
SURROUND/DSP
OFF
DIMMER
INPUT DIGITAL
RX–6030V
AUDIO/VIDEO CONTROL RECEIVER
INPUT ANALOG
INPUT ATT
FM/AM RESET
SOURCE NAME
Front panel Remote control
SURROUND
REMOTE CONTROL RM-SRX
6030J
DISPLAY MODE
2
Press SURROUND.
The appropriate Surround mode will be activated
according to the incoming signal.
• DOLBY DIGITAL:
Activated if you are playing back multi-channel
software encoded with Dolby Digital.
• DTS SURROUND:
Activated if you are playing back software encoded
with DTS Digital Surround.
• PL II MUSIC* or PL II MOVIE:
Activated if you are playing back any software other
than the above. (The last one selected will be
activated.)
The
PRO LOGIC II indicator lights up on the
display.
Press SURROUND repeatedly to select the one
appropriate for the source.
*
When “PL II MUSIC” is selected, you can select Panorama control
to enjoy “wraparound” sound effect with side-wall image (see
page 19 for the setting procedure).
Notes:
• When “DOLBY DIGITAL” or “DTS SURROUND” is selected with
no surround speakers connected, the surround sounds are
downmixed and output from the front speakers.
• For the available Surround modes according to the input signals,
see “Available Surround/DSP modes for each input signal” on
page 25.
To adjust the speaker output level and select Panorama
control for Pro Logic II Music, see pages 19 to 21.
The adjustment is memorized for each source (except for
Panorama control).
To turn off Surround mode, press SURROUND/DSP OFF.
24-27_RX-60_5030[J]f 02.11.28, 13:4826