Filter
Top Products
11
Playing Back from Other Equipment
To connect other equipment
By using a stereo mini plug cord (not supplied), you can
connect other equipment with analog audio output jacks,
such as Digital Audio Player, a TV, etc.
• Refer to the manuals supplied with the other equipment.
NOTE
• Always set volume to the minimum level when connecting
or disconnecting the other equipment.
To select other equipment for the source
To adjust the sound input level from other
equipment
You can adjust the sound input level from the connected
equipment, if the incoming signal is too small or too large.
If you are having a problem with your System, check this list for a possible solution before calling for service.
General:
Power does not come on.
Power plug is not inserted securely. Plug in securely.
Adjustments or settings are suddenly canceled
before you finish.
There is a time limit. Repeat the procedure again.
Operations are disabled.
The built-in microprocessor may malfunction due to
external electrical interference. Unplug the AC power
cord and then plug it back in.
Unable to operate the System from the remote
control.
The path between the remote control and the remote
sensor on the System is blocked.
Point it at the remote sensor on the font panel.
Signals cannot reach the remote sensor.
More closer to the System.
The batteries are exhausted.
No sound is heard from the speakers.
Speaker connections are incorrect or loose (P.4).
Headphones are connected (P.5).
Sound from PC connected with a USB cable has
some noise. (P.10)
PC is subjected to excessive load due to using other
applications. Close the applications you do not use.
PC is connected via USB Hub. Connect the PC directly
to the main unit with a USB cable.
iPod/USB mass storage class device Operations:
The iPod doesn’t playback although the display
indicates CONNECT.
The battery is empty. Let stand for more than
approximately ten minutes on the connecting condition.
Timer Operations:
Daily Timer does not work.
The System has been turned on when the ontime comes.
Timer starts working only when the System is turned
off.
There might have been a power failure.
Set the clock first, then the timer again.
Stereo mini plug cord (not supplied)
AUX
(front panel)
Portable audio
device, Game
machine, etc.
Select AUX for the source.
• AUX can be selected also by the FUNCTION
button on the unit.
1
Select AUX for the source.
2
Press and hold until the indicator appears on the
display. Then press and hold until setting is changed.
LEVEL 1:
Decreased input level. Suitable for equipment with high output
level (such as a DVD player).
LEVEL 2:
Ordinary input level (factory setting).
Suitable for equipment with low output level (such as a portable
audio device).
USB AUDIO
AUX
LEVEL 1
LEVEL 2
Troubleshooting
NX-PS1[J].BOOK Page 11 Friday, October 27, 2006 5:02 PM