Filter
Top Products
10
Repeat Play Random Play
This System is equipped with a USB AUDIO terminal on the rear panel. You can connect your PC to this terminal and enjoy
the sound from your PC. When you connect your PC for the first time, follow the procedure below.
How to install the USB drivers
NOTE
• Always set volume to the minimum level when connecting
or disconnecting the other equipment.
To playback sounds on the PC
Refer to the manuals supplied with the media player
application installed on the PC.
* Microsoft
®
, Windows
®
98SE, Windows
®
Me,
Windows
®
2000 and Windows
®
XP
are registered trademarks of Microsoft corporation.
NOTES
• You cannot send any signal or data to your PC from this
System.
• DO NOT turn off the unit or disconnect the USB cable
while installing the drivers and for several seconds while
your PC is recognizing the receiver.
• Use a full speed USB cable (version 1.1).
Recommended cord length is shorter than approximately 2
m.
• If your PC does not recognize the unit, disconnect the USB
cable and connect it again. If it does not work yet, restart
Windows.
• The installed drivers can be recognized only when the USB
cable is connected between the unit and your PC.
• The sound may not be played back correctly— interrupted
or degraded—due to your PC settings and PC
specifications.
1
Press repeatedly before you start playback to specify
the repeat mode as follows:
1 Repeats the current track.
ALL Repeats all tracks.
GR Repeats all tracks in the current group.
Cancel
2
Start playback.
1
RND appears on the display before you start
playback.
• To cancel, press again.
2
Playback starts in random order.
Random Play ends when all tracks are played.
• To repeat random play, press REPEAT.
Playing Back from the PC
1
Turn on your PC and start running Windows
®
98SE,
Windows
®
Me, Windows
®
2000, or Windows
®
XP.
• If the PC has been turned on, close all the
applications running.
2
Select USB AUDIO for the source.
• USB AUDIO can be selected also by the
FUNCTION button on the unit.
3
Connect the System to the PC using a USB cable (not
supplied).
• Use “USB series A plug to B plug” cable.
4
The USB drivers are installed automatically.
USB AUDIO
AUX
(rear panel)
USB cable
(not supplied)
PC
NX-PS1[J].BOOK Page 10 Friday, October 27, 2006 5:02 PM