Filter
Top Products
25
ENGLISH
EU
US
Changing the AM/FM channel intervals
When this unit is shipped from the factory, the channel intervals are set to 10 kHz for AM and
200 kHz for FM (US settings).
You will have to change the channel intervals when using this unit in an area other than North
America and South America.
• EU: Select this when using this unit in an area other than North and South America. (9
kHz for AM and 50 kHz (for manual tuning) / 100 kHz (for searching) for FM)
• US: Select this when using this unit in North or South America. (10 kHz for AM and 200
kHz for FM)
1. Press and hold SEL (Select) for more than 2 seconds so that “PSM” appears on the lower
part of the display.
2. Select “AREA (with its current setting)” with ¢
or 4 .
3. Select the correct channel intervals with the control dial.
The channel intervals alternate between EU settings and US settings.
Turning on or off the power amplifier switch
You can switch off the built-in amplifier and send the audio signals only to the external
amplifier(s) to get clear sounds and to prevent internal heat buildup. When shipped from the
factory, the power amplifier switch is turned on so that built-in amplifier works.
• ON: Select this when not using external power amplifier(s).
• OFF: Select this when using external power amplifier(s).
1. Press and hold SEL (Select) for more than 2 seconds so that “PSM” appears on the lower
part of the display.
2. Select “P.AMP (with its current setting)” with ¢
or 4 .
3. Select the desired mode with the control dial.
The power amplifier switch alternates between on and off.
ON
OFF
EN 21-32 KD-MX3000 [J]/F 98.10.19, 6:51 PM25