Filter
Top Products
7
ENGLISH
Searching a station manually: Manual search
2, 3
1-
1
1-
3
1-
2
1
Select the band.
1 Press FUNC (Function) to select “FM” or
“AM.”
2 Press MODE.
“MODE” appears on the lower part of the
display.
3 Press BAND to select the band.
Each time you press the button, the band
changes as shown to the left:
2
Press and hold ¢ or 4
until “M” (manual)
starts flashing on the display.
3
Tune into a station you want while “M”
is flashing.
Notes:
• If you hold down the button, the frequency keeps changing (in 50 kHz intervals for FM and 9
kHz intervals for AM–MW/LW) until you release the button.
• After 5 seconds you release the button, “M” stops flashing on the display and you cannot select
a station manually any more.
When an FM stereo broadcast is hard to receive:
1 Press MODE while listening to an FM stereo broadcast (the ST indicator lights up while
receiving an FM stereo broadcast).
“MODE” appears on the lower part of the display.
2 Press MONO (monaural), while “MODE” is still on the display, so that the MO indicator
lights up on the display.
The sound you hear becomes monaural but reception will be improved (the ST indicator
goes off).
Each time you press the button, the MO indicator lights up and goes off alternately.
1
2
3
FM1 FM2 AMFM3
Note:
This receiver has three FM bands (FM1, FM2,
FM3). You can use any one of them to listen to
an FM broadcast.
To tune into stations
of higher frequencies
To tune into stations
of lower frequencies
MODE
MONO
EN06-10.KD-LX3R[E]/f 99.3.9, 6:14 PM7