Filter
Top Products
KD-G814
Installation/Connection Manual
GET0306-002A
[UI]
0105DTSMDTJEIN
EN
This receiver is designed to operate on 12 V DC, NEGATIVE ground electrical systems. If your vehicle does not have this system, a voltage inverter is required, which can be purchased at JVC
car audio dealers.
J
Handles
F
Washer (ø5)
G
Lock nut (M5)
H
Mounting bolt (M5 x 20 mm)
I
Rubber cushion
A / B
Hard case/Control panel
D
Tr im plate
E
Power cord
Parts list for installation and connection
The following parts are provided for this receiver.
After checking them, please set them correctly.
1
INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this receiver correctly, have it installed by a qualifi ed technician.
Do the required electrical connections.
*
1
When you stand the receiver, be
careful not to damage the fuse on
the rear.
Bend the appropriate tabs to hold
the sleeve fi rmly in place.
C
Sleeve
L
Battery
K
Remote controller
Removing the receiver
Before removing the receiver, release the rear section.
Insert the two
handles, then pull
them as illustrated
so that the
receiver can be
removed.
When installing the receiver without using the
sleeve
In a Toyota for example, fi rst remove the car radio and install
the receiver in its place.
When using the optional stay
Note : When installing the receiver on the mounting
bracket, make sure to use the 8 mm-long screws.
If longer screws are used, they could damage the
receiver.
Bracket*
Bracket*
2
*
2
Not included for this receiver.
Flat type screws
(M5 x 8 mm)*
2
Pocket
Flat type screws
(M5 x 8 mm)
*
2
Screw (option)
Stay (option)
Fire wall
Dashboard
Install the receiver
at an angle of less
than 30˚.
PRECAUTIONS on power supply and speaker connections:
• DO NOT connect the speaker leads of the power cord to the car battery; otherwise,
the receiver will be seriously damaged.
• BEFORE connecting the speaker leads of the power cord to the speakers, check the
speaker wiring in your car.
• Noise interfere with sounds.
* Is the rear ground terminal connected to the car’s chassis using shorter and thicker cords?
• Receiver becomes hot.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
• This receiver does not work at all.
* Have you reset your receiver?
Fit the protusions outside
the receiver.
Fit the receiver into the mounting sleeve by using four corners of the trim plate.
• DO NOT press the panel (shaded in the illustration).
Caution when installing
TROUBLESHOOTING
• The fuse blows.
* Are the red and black leads connected correctly?
• Power cannot be turned on.
* Is the yellow lead connected?
• No sound from the speakers.
* Is the speaker output lead short-circuited?
• Sound is distorted.
* Is the speaker output lead grounded?
* Are the “–” terminals of L and R speakers grounded in common?
Instal1-2_KD-G814_002A_f.indd 1Instal1-2_KD-G814_002A_f.indd 1 1/27/05 11:35:23 AM1/27/05 11:35:23 AM