Filter
Top Products
23
English
The following settings are required after connecting and positioning your speakers.
You can adjust the items by using the ADJUST button and CONTROL 5/∞/2/3 buttons on the front panel.
Adjustment items:
• Front speaker output balance* • Tone* • Speaker output levels*
• DAP effect level
Notes:
• The setting contents of adjustment items are memorized for each source.
*
You can also set these items using the Choice menu (see pages 49 to 54).
Sound Adjustments
Operation Buttons
To do the basic settings for this unit, use the buttons on the front
panel.
• When no operation is done for about 5 seconds, the indications
on the display will disappear.
* You can also make sound adjustment except for front speakers
output balance from the remote control.
** Pressing ADJUST repeatedly also changes the indication.
Configuration of the indications on the display
On the front panel ONLY*
Button
ADJUST
CONTROL 5/∞
CONTROL 3/2
To do
Display the adjustment indications on
the display**.
Select an item on the display.
Each time you press the button, the
indication changes as illustrated below.
Adjust the selected item.
Operating Procedure
Ex. : When setting the front speaker output balance.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1
again.
1
Press ADJUST.
The CONTROL buttons now work for sound
adjustments. The setting item selected previously
appears on the display.
2
Press CONTROL ∞ (or 5)
repeatedly until “BAL (Balance)”
(with the current setting)
* appears
on the display.
* “CENTER” is the initial setting. If you have already changed
the setting, another setting will be shown.
3
Press CONTROL 3 (or 2) to adjust
the front speaker balance.
• Each time you press the button, the indication
changes as follows:
ADJUST
CONTROL
BAL
(Balance)
BASS
TREBLE
SUBWFR
(Subwoofer)
CENTER
REAR L
(Rear left)
REAR R
(Rear right)
EFFECT
#
#
#
#
#
#
#
These indications appear only when the corresponding speakers
information for each speaker is set to other than “NO.”
##
“EFFECT” appears only when one of DAP modes (see pages 25
to 28) is activated.
ADJUST
CONTROL
SPK.
DIGITAL AUTO
VOLUME
LR
CONTROL
SPK.
DIGITAL AUTO
VOLUME
LR
CENTERR –21 L –21
EN19-24RX-DV5SL[C]4.pm5 02.8.5, 5:33 PM23