Filter
Top Products
19
English
Basic Settings
Some of the following settings are required after connecting and positioning your speakers while others will make operations easier.
You can set the items by using the SETTING button and CONTROL 5/∞/2/3 buttons on the front panel.
Setting items:
• Speaker information for front, center, rear speakers, and subwoofer* • Speaker distance for front, center, and rear speakers*
• Crossover frequency* • Low frequency effect attenuator* • Dynamic range compression*
• Digital input (DIGITAL IN) terminals • Auto surround • Video output mode
Note:
*
You can also set these items using the Choice menu (see pages 49 to 54).
Operation Buttons
To do the basic settings for this unit, use the buttons on the front
panel.
• When no operation is done for about 5 seconds, the indications on
the display will disappear.
* Pressing SETTING repeatedly also changes the indication.
Configuration of the indications on the display
Operating Procedure
Ex. : When setting the digital input (DIGITAL IN) terminals.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step
1
again.
1
Press SETTING.
The CONTROL buttons now work for basic settings.
The setting item selected previously appears on the
display.
2
Press CONTROL ∞ (or 5)
repeatedly until “DGT (Digital)”
(with the current setting)
* appears
on the display.
* “1DBS 2TV” is the initial setting. If you have already changed
the setting, another combination will be shown.
3
Press CONTROL 3 (or 2) to select
the appropriate digital terminal
setting.
• Each time you press the button, the indication
changes as follows:
SETTING
CONTROL
On the front panel ONLY
Button
SETTING
CONTROL 5/∞
CONTROL 3/2
To do
Display the setting indications on the
display*.
Select an item on the display.
Each time you press the button, the
indication changes as illustrated below.
Adjust the selected item.
SETTING
CONTROL
SPK.
DIGITAL AUTO
VOLUME
LR
CONTROL
DIGITAL AUTO
VOLUME
DGT1DBS 2TV DGT1DBS2CDR
DGT1TV 2DBS
DGT1CDR2DBS
DGT1CDR 2TV
DGT1TV 2CDR
LR
(back to the beginning)
SPK.
SUBWFR
(Subwoofer)
FRNT SP
(Front speaker)
CNTR SP
(Center speaker)
REAR SP
(Rear speaker)
FRNT D
(Front distance)
CNTR D
(Center distance)
REAR D
(Rear distance)
CROSS
(Crossover)
LFE
(Low frequency effect)
D.COMP
(Dynamic range compression)
DGT
(Digital)
AUTO SR
(Auto surround)
VOUT
(Video out)
EN19-24RX-DV5SL[C]4.pm5 02.8.5, 5:33 PM19