Filter
Top Products
11
RIGHT LEFT
PHONO
CD
CDR
TAPE
MD
OUT
(REC)
IN
(PLAY)
OUT
(REC)
AUDIO
IN
IN
R
L
Connecting Audio/Video Components
When connecting individual components, refer also to the manuals
supplied with them.
Analog Connections
Audio component connections
Use the cables with RCA pin plugs (not supplied).
• Connect the white plug to the audio left jack, and the red plug to
the audio right jack.
CAUTION:
If you connect a sound-enhancing device such as a graphic equalizer
between the source components and this receiver, the sound output
through this receiver may be distorted.
CD player
To audio input
To audio output
If your audio components have a COMPU LINK or TEXT
COMPU LINK jack
• See page 61 for detailed information about the connection and
the COMPU LINK remote control system.
• See page 63 for detailed information about the connection and
the TEXT COMPU LINK remote control system.
CD recorder
Turntable
Rear view
If an earth cable is
provided for your
turntable, connect
the cable to the
screw marked (H)
on the rear panel.
To audio output
Turntable
To audio output
CD player
RIGHT LEFT
PHONO
CD
TAPE
MD
OUT
(REC)
IN
(PLAY)
AUDIO
IN
R
L
IN
Cassette deck or MD recorder
To audio output
To audio input
Cassette deck
CD
CDR
TAPE
MD
OUT
(REC)
IN
(PLAY)
OUT
(REC)
IN
R
L
R
L
MD recorder
To audio output
To audio input
Note:
You can connect either a cassette deck or an MD recorder to the
TAPE/MD jacks. When connecting an MD recorder to the TAPE/MD
jacks, change the source name to “MD,” which will be shown on the
display when selected as the source. See “Changing the Source
Name” on page 27 for details.
CDR
TAPE
MD
OUT
(REC)
IN
(PLAY)
OUT
(REC)
FRONT
IN
(PLAY)
R
L
R
L
Note:
This connection is for the turntable with an MM (moving-magnet) type
cartridge.
Any turntables incorporating a small-output cartridge such as an MC
(moving-coil) type must be connected to this receiver through a
commercial head amplifier or step-up transformer. Direct connection
may result in insufficient volume.
CD recorder
01-18_RX-DP15B[J]f.pm6 04.3.15, 9:26 PM11