JVC RX-6040B Stereo System User Manual


 
5
English
AM
LOOP
AM
EXT
ANTENNA
COAXIAL
FM 75
FM 75
COAXIAL
AM
LO
OP
AM
EXT
ANTENNA
FM 75
COAXIAL
AM
LO
OP
AM
EXT
ANTENNA
Getting Started
This section explains how to connect audio/video components and speakers to the receiver, and how to connect the
power supply.
Before Installation
General Precautions
Be sure your hands are dry.
Turn the power off to all components.
Read the manuals supplied with the components you are going to
connect.
Locations
Install the receiver in a location that is level and protected from
moisture and dust.
The temperature around the receiver must be between –5˚C
and 35˚C.
Make sure there is good ventilation around the receiver. Poor
ventilation could cause overheating and damage the receiver.
Handling the receiver
Do not insert any metal object into the receiver.
Do not disassemble the receiver or remove screws, covers, or
cabinet.
Do not expose the receiver to rain or moisture.
Checking the Supplied Accessories
Check to be sure you have all of the following items, which are
supplied with the receiver.
The number in the parentheses indicates quantity of the pieces
supplied.
Remote Control (1)
Batteries (2)
AM Loop Antenna (1)
FM Antenna (1)
If anything is missing, contact your dealer immediately.
Putting Batteries in the Remote Control
Before using the remote control, insert the two supplied batteries
first.
1 Press and slide the battery cover on the back of
the remote control.
2 Insert the batteries.
Make sure to match the polarity: (+) to (+) and (–) to (–).
3 Replace the cover.
If the remote control cannot transmit signals or operate the receiver
correctly, replace the batteries. Use two R6(SUM-3)/AA(15F) type
dry-cell batteries.
Notes:
Supplied batteries are for the initial setup. Replace for continued
use.
After replacing the batteries, set the manufacturers codes again
(see pages 35 and 36).
CAUTION:
Follow these precautions to avoid leaking or cracking cells:
Place batteries in the remote control so they match the
polarity: (+) to (+) and () to ().
Use the correct type of batteries. Batteries that look similar
may differ in voltage.
Always replace both batteries at the same time.
Do not expose batteries to heat or flame.
Connecting the FM and AM Antennas
FM antenna connections
Connect the supplied FM antenna as temporary measure to the
FM 75 COAXIAL terminal—A
If reception is poor, connect the outdoor FM antenna (not
supplied)—B
1 Disconnect the supplied FM antenna.
2 Connect a 75 coaxial cable (with the standard type connector).
1
2
R6(SUM-3)/
AA(15F)
3
B
FM Antenna
(supplied)
Outdoor FM Antenna Cable
(not supplied)
Extend the supplied FM antenna
horizontally.
A
01-10_5040&6040[C]f.p65 1/13/04, 7:12 PM5