Filter
Top Products
4
English
It is recommended that memory backup batteries are loaded in the System to prevent the contents of the memory from being erased when a
power failure occurs.
■
1. Open the battery cover on the back of the System by pulling it toward you while pressing the
tabs as shown by the arrows.
■
2. Load three batteries (not supplied) in the battery compartment in the order of "1" to "3".
• Be careful to put the batteries with the "+" and "–" terminals positioned correctly.
■
3. Securely close the battery cover.
To remove the batteries, remove the battery "3" first.
Notes:
• The memory backup batteries will not be consumed as long as the power is supplied from an AC outlet, loaded 10 batteries, or car battery
(DC12V). However, if no power is supplied to the System, the memory backup batteries should be replaced with new ones approximately
every 12 months to securely maintain the contents of the memory.
• Before replacing the memory backup batteries, always connect the AC power cord to the System to prevent the contents of memory from
being erased.
• When a power failure occurs, the time indication disappears from the display to save the battery power of the memory backup batteries.
CAUTION: Handle batteries properly.
To avoid battery leakage or explosion:
• When you need to replace the batteries, replace all batteries at the same time with new ones. Before replacing, you need to supply AC power
to the System.
• Don't use an old battery with new ones.
• Don't use different types of batteries together.
You can operate the System on 10 batteries.
■
1 Open the battery cover on the back of the System by pulling it toward you while pressing the
tabs as shown by the arrows.
■
2. Put 10 batteries (not supplied) in the battery compartment in the order of "1" to "10" as shown.
• Be careful to put the batteries with the "+" and "-" terminals positioned correctly.
■
3. Securely close the battery cover.
To remove the batteries, remove the battery "10" first.
Notes:
• When you operate the System on mains (AC) power or on car battery (DC12V), the power source automatically switches from batteries to
AC or DC12V. However, you should remove the 10 batteries when operating on AC power or car battery (DC12V).
• When the batteries are exhausted, mistracking will occur during CD playback or sound will be distorted intermittently during tape playback.
You need to replace the batteries at a time.
• It is recommended that the AC power cord be used when recording important material or listening to a CD.
Memory Backup Batteries
How To Operate the System on Batteries
2
3
1
Battery cover
"R6P (SUM-3) / AA (15F)" size batteries
4
5
3
2
1
9
8
7
6
10
"R20/D (13F)" size batteries
RD-DP100(E)-Eng.fm Page 4 Monday, March 6, 2000 10:32 AM