Filter
Top Products
7
ENGLISH
Basic operations
Listening to the sound from the base
station
The base station works as the FM transmitter
and send sound to the headphones.
Precaution
Turn down the volume of the headphones with
the VOL dial before turning on its power to
avoid excessive volume.
1 Start playback on the AV
equipment connected with the
base station.
The base station turns on automatically and
starts to transmit FM signals (Auto Power
On function).
The POWER indicator of the base station
lights up.
• In some situations, the power may not
be turned on automatically by the input
sound (e. g. a song with a quiet opening
or fade in). This is not a malfunction.
2 Press POWER on the
headphones to turn on the
power.
The POWER indicator lights up and the
headphones automatically starts to tune in
to the signal from the base station (Auto
Tuning function).
The AUTO SCAN indicator lights up when
tuned in.
• Press the center of the button firmly
when pressing POWER. Pressing the
edge may not turn on the power.
• Charge the battery in the following cases.
The battery ran out:
– The POWER indicator does not light
up after pressing POWER.
– The AUTO SCAN indicator does not
light up though the POWER indicator
lights up.
• No sound is heard while Auto Tuning. It
takes a few seconds to tune in.
• Press AUTO SCAN when
the sound does not come out
properly.
3 Adjust the volumes of the
AV equipment and the
headphones.
• Adjust the volumes within the area about
7 m (23 ft.) from the base station to get
optimum signal reception.
• You can get better sound by setting the
volume of the AV equipment as high
as possible without causing distortion
and that of the headphone lower (except
when connecting the AV equipment
through LINE OUT jacks).
To Turn off the units
Press POWER on the headphones and
stop playback on the AV equipment.
The headphones’ POWER indicator
goes off.
• The base station automatically turns off if no
signals come in for about four minutes (Auto
Power OFF function).
• The white noise may come out when the base
station turns off. Take off and turns off the
headphones after using.
HAW600RF_J.indb 7HAW600RF_J.indb 7 06.6.16 11:11:45 AM06.6.16 11:11:45 AM