References
44
7
Center unit (XV-THC9/XV-THC6/XV-THC3)
Audio section
Total Harmonic Distortion 0.02 %
NOTE: This value is measured at System cord CONNECTOR for
reference.
Digital input*
1
:
DIGITAL IN (DBS): –21 dBm to –15 dBm
(OPTICAL) (660 nm E30 nm)
*
1
Corresponding to Linear PCM, Dolby Digital, and DTS Digital
Surround (with sampling frequency — 32 kHz, 44.1 kHz, 48 kHz)
Video section
Video System: PAL/NTSC
Horizontal Resolution: 500 lines
Signal-to-Noise Ratio: 64 dB
Video output level
Composite: 1.0 V(p-p)/75 C
S-video-Y: 1.0 V(p-p)/75 C
S-video-C: For PAL: 0.3 V(p-p)/75 C
For NTSC: 0.286 V(p-p)/75 C
Component-Y: 1.0 V(p-p)/75 C
Component-P
B/PR: 0.7 V(p-p)/75 C
Video input sensitivity/Impedance (VCR IN)
Composite: 1.0 V(p-p)/75 C
S-video-Y: 1.0 V(p-p)/75 C
S-video-C: For PAL: 0.3 V(p-p)/75 C
For NTSC: 0.286 V(p-p)/75 C
Tuner section
Tuning Range
FM: 87.5 MHz to 108.0 MHz
AM: Except for Middle East
531 kHz to 1 710 kHz
(at 9 kHz channel spacing)
530 kHz to 1 710 kHz
(at 10 kHz channel spacing)
For Middle East
531 kHz to 1 602 kHz
(at 9 kHz channel spacing)
530 kHz to 1 600 kHz
(at 10 kHz channel spacing)
General
Power Requirements: AC 110-240 V , 50/60 Hz
Power Consumption: 19 W (at operation)
1.9 W (in standby mode)
Dimensions (W M H M D):
400 mm M 85 mm M 399 mm
Mass: 4.2 kg
7 Subwoofer (SP-PWC9)
Amplifier section
Front/Center/Surround: 140 W per channel, RMS at 4 C
at 1 kHz, with 10% total harmonic
distortion.
Subwoofer: 300 W, RMS at 4 C at 40 Hz, with
10% total harmonic distortion.
Speaker section
Speaker unit: 25 cm Bass-reflex
Power Handling Capacity: 300 W
Impedance: 4 C
Frequency Range: 25 Hz to 200 Hz
General
Power Requirements: Except for Australia
AC 110 V/ AC 127 V/
AC 220-240 V , 50/60 Hz
For Australia only
AC 240 V , 50 Hz
Power Consumption: 110 W (at operation)
0 W (in standby mode)
Dimensions (W M H M D):
264 mm M 481 mm M 459 mm
Mass: 17.6 kg
7 Subwoofer (SP-PWC6/SP-PWC3)
Amplifier section
Front: 140W per channel, RMS at 4 C at
1 kHz, with 10% total harmonic
distortion.
Center/Surround: 130W per channel, RMS at 4 C at
1 kHz, with 10% total harmonic
distortion.
Subwoofer: 140 W, RMS at 4 C at 100 Hz, with
10% total harmonic distortion.
Speaker section
Speaker unit: 16 cm Bass-reflex
Power Handling Capacity: 140 W
Impedance: 4 C
Frequency Range: 30 Hz to 200 Hz
General
Power Requirements: Except for Australia
AC 110 V/ AC 127 V/
AC 220-240 V , 50/60 Hz
For Australia only
AC 240 V , 50 Hz
Power Consumption: 135 W (at operation)
0 W (in standby mode)
Dimensions (W M H M D):
169 mm M 411 mm M 459 mm
Mass: 11.3 kg
Specifications
TH-C3C6C7C9[AUWUSUNUGUX].book Page 44 Monday, April 25, 2005 8:56 PM