JVC GVT0150-008US Home Theater System User Manual


 
Connections
12
Note that the illustration below is for SP-PWC6.
CAUTION
When you connect speakers other than the supplied ones, use
speakers of the same speaker impedance (SPEAKER IMPEDANCE)
indicated near the speaker terminals on the rear of the powered
subwoofer.
DO NOT connect more than one speaker to one speaker terminal.
Precautions for daily use
When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or injury.
Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by internal
heat buildup.
(For TH-C6)
When holding a speaker, always grasp the lower portion.
Do not lean against the speakers, as the speakers could fall down
or break, possibly causing an injury. Especially be careful that
children do not lean against them.
CAUTION:
SPEAKER IMPEDANCE
4
16
Connect the black cords to the black (r) terminals.
Connect the white cords to the (q) terminals
referring to the table below:
Speaker cord
FRONT SPEAKERS (LEFT) White
FRONT SPEAKERS (RIGHT) Red
CENTER SPEAKER Green
SURROUND SPEAKERS (LEFT) Blue
SURROUND SPEAKERS (RIGHT) Gray
Before connecting the speaker cords;
Twist and pull the insulation coat off and remove.
Powered subwoofer
TH-C6: SP-PWC6
TH-C3: SP-PWC3
Front speakers
TH-C6: SP-THC6F
TH-C3: SP-THC3F
Surround speakers
TH-C6: SP-THC6S
TH-C3: SP-THC3S
Center speaker
TH-C6: SP-THC6C
TH-C3: SP-THC3C
Do not connect the power cord until all other connections have been made.
This page is except for TH-C9.
TH-C3C6C7C9[AUWUSUNUGUX].book Page 12 Monday, April 25, 2005 8:56 PM