Filter
Top Products
• Preset Tuning using the Remote Control
(Possible only after presetting stations)
Select the desired preset number using the I_ or <1
button on the Remote Contmh The display will show
the preset number's band and frequency.
• You can also select the desired preset number
using the Nmneric Keys. See "Entering the
Nmnber with the Remote Control" on page 12.
(e.g. Press +10, and then 2 for number 12.)
Example:
Press the I_ button until the preset nmnber "2" ap-
pears.
UP
Preset number
DOWN
or@FH
i-i -.=" _l-a
"J. "=.. I1,'1
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM sta-
tions.
• Preset numbers may have been set to factory lost fro-
quencJes prior to shipment. This L<not a malfunction. You
can preset the stations you want into memory by following
one of the presetting methods below.
1 STORED
FM/AM / I\ / I \
or!t
T
W_en Changing the Band
Onthe Remote Control
1 Select a band by pressing the FM/AM
button.
2 Press the • or • button to tune in a sta-
tion.
3 Press the SET button.
Preset number "l" will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns Io the one set in step 2 after 5
seconds, press the SET button again.
Using the Tuner
4 Press the Numeric Keys, or the _ or <
button within 5 seconds to select the
preset number.
Example:
\tl/
/11\
Press the SET button within 5 seconds,
"STORED" appears and after 2 seconds, the display re-
turns to the broadcast frequency display.
6 Repeat above steps 1 to 5 for each sta-
tion you want to store in memory with a
preset number.
To change the preset stations, repeat the same
steps &s above.
CA UTION:
• Even if the system is unplugged or if the
power failure occurs, the preset stations
will be stored for about 24 hours. However,
in case the preset stations are erased, you
will need to preset the stations again.
To Change the FM Reception
Mode
When you are tuned into an FM stereo broadcast, the "ST."
indicator lights up and you can hear stereo effects.
If an FM stereo broadcast is hard to receive or noisy, you
can select Monaural mode. Reception improves, but you
lose stereo effect.
FM AUTO mode is also useful Io suppress static noise be-
tween stations.
To enter Monaural mode while receiving an FM
broadcast, press the FM/PLAY MODE button on the Re-
mote Control unlil "FM MONO" appears on the display. Then,
the "MONO" iodicator lights up.
Each time you press the FM/PLAY MODE button, the display
alternates between "FM AUTO" and "FM MONO".
FM/pLAy
MODE
FM AUTO _ FM MONO
To restore the stereo effect, press the FM/PLAY
MODE button on the Remote Conlrol until "FM AUTO" ap-
pears on the display. Then, the "MONO" indicator goes out
and the "ST." indicator will light up.
g
14