Filter
Top Products
Tone Control (BASS/TREBLE)
You can control the tone by changing the bass (low frequen-
cy) and treble (high frequency).
On the Remote Control
1 Press the BASS/TREBLE button.
Each time you press the button, the Tone Control mode
changes as follows.
BASS _ TREBLE --_ Normal display --_ (back Io the
beginning)
2 While "BASS" or "TREBLE" appears on
the display, press the VOLUME + or -
button to adjust the bass or treble level.
You can change the level within the range of -5 to +5. (0: flat)
z._zI zz z :
.,.,.i.'--,--, .-,-
Tnrn, r _r_
I RI-I--,I r
3 Press the BASS/TREBLE button until
normal display appears.
Waiting for five seconds will also return the Syslem to
the normal display.
Auto Power Off (A.P.off)
You can aulomalically turn off the System when no signal
condition continues for three minules. This function is ef-
fective when the source is set to "CD", but not to "FM",
"AM" or" LINE".
To Enable the A.P.off function
(When the source is "CD")
1 Press the A.P.off button on the Remote
Control until "A.P.off SET" appears on
the display.
Then, the "A.P.off" indicator lights up on the display.
AR_
| | | | m i', _ | | |
H= r [];_;T + _-,r i
• Each time you press the button, the display allernates
as follows.
A.P.off SET _ A.P.off STOP
When no signal condition is delecled, the "A.P.off" indica-
tor will start blinking soon.
Basic Operations
No signal condition:
Source CD: CD is stopped or no CD is inserled.
When no signal condition continues, "A.P.off 20 sec" (20
seconds left before elapsed time reaches three minutes) ap-
pears on the display. The displayed time is counted down
and, finally, the System is turned off (Standby mode).
• If a CD is played back, the "A.Roff" indicator slops
blinking and stays lit again.
• If you press a button or turn the VOLUME control,
three-minute counting down is reset and counting down
newly testings.
To disable the A.P.offfunction
When the source is "CD", press the A.P.off button on the
Remote Control until "A.P.off STOP" appears on the dis-
play.
Then, Ihe "A.P.off" indicator goes out.
Entering the Number with the
Remote Control (Numeric Keys)
You will use the Nmneric Keys on Ihe Remote Control to
enter numbers for presetting stations, recalling the preset
stations, selecting track number, or programming the play-
ing tracks on a CD.
How to enter the number with the Numeric Keys is ex-
plained here.
Examples:
• To enter number 5, press 5.
• "Ik_enter number 10, press 10.
• "Ik_enter number 15, press +10 then 5.
• "Ik_enter number 20, press +10 then 10.
• To enter number 25, press +10, +10, then 5.
12