JVC CA-V808T Stereo System User Manual


 
42
English
6.Setting the Volume Level.
Adjust the MULTI CONTROL stick left or right to set the volume level.
VOLUME - A: Sets the volume level to 10.
VOLUME - B: Sets the volume level to 15.
VOLUME - C: Sets the volume level to 20.
VOLUME - - : Sets the volume to the last volume setting used.
7.Press the SET/DEMO button.
The “DAILY” indicator changes from a blinking display to a steady display. The ON TIME,
OFF TIME, PLAYBACK SOURCE (including the disc number and track number if a CD
source is selected) are displayed then the display reverts to the previous display, before the
Timer was set.
Turn the power off if you made the timer settings with the power turned on.
A few seconds before the start for the timer, the CA-V808T automatically turns on the power,
and the “DAILY TIMER” blinks on the display. When the set time is reached, playback starts
using the selected source. After the finish time for the timer is reached, the power is automati-
cally turned off again.
If a button is pressed when the DAILY Timer is operating, playback continues but the timer is
cancelled.
Before Turning Off the Unit
If the source is a CD, make sure that there is a CD in the selected disc number.
If the source is a tape:
The tape in the deck corresponding to the Deck indicator mark is played. Make sure that
there is a tape in the selected Cassette Deck.
Check that the tape direction is correct. This is important especially when Reverse Mode is
off.
Set Reverse Mode on if you want to play both sides of the tape.
Select the Sound Mode if you want to listen using a Sound Mode effect.
To Change the DAILY Timer Setting
To change the settings for the DAILY Timer, repeat the setting procedure from the beginning.
Turning the DAILY Timer On and Off —————————————————
Once the DAILY Timer has been set, it will be activated at the same time every day until the setting
is turned off.
To turn the DAILY Timer off, press the TIMER/CLOCK button until “DAILY” appears in the display.
Press the CANCEL button, “OFF” appears in the display and the DAILY indicator goes out.
To turn the DAILY TIMER on again, press the TIMER/CLOCK button until “DAILY” appears in the
display, then press the SET/DEMO button. The Timer ON TIME, OFF TIME, PLAYBACK
SOURCE (including the disc number and track number if a CD source is selected) are displayed on
the display.
Note:
DAILY Timer function may not work properly if you are doing other operation at the time you
set in the DAILY Timer.
CAUTION: If the CA-V808T is unplugged, or a power failure occurs, the timer setting will be erased
in a few days. If the settings are erased in this way, reset the timer settings.
SET
/
DAILY