Filter
Top Products
ENGLISH
37
EXTERNAL COMPONENT OPERATIONS
Playing external components
You can connect two external components to this
unit.
Connect one to the auxiliary input jack on the
control panel, and the other to the LINE IN plugs
on the rear.
You can connect a JVC DVD player or VCR
to the LINE IN plugs.
You can operate a JVC DVD player or VCR
through this receiver using the number
buttons on the control panel.
When you operate the VCR, you have to
change the operation mode of the number
buttons from the DVD operation mode to the
VCR operation mode. (See “To select the
target component to operate through this
receiver – KEY SELECT” on page 33.)
If the input level of the external
components is not high enough, increase
the input level properly.
Without adjusting the input level, you may be
surprised at a loud sound when you change
the source from the external components to
another. (See “To adjust the line input level –
LINE ADJ” and “To adjust the auxiliary input
level – AUX ADJ” on page 33.)
1
Select the external component (AUX
INPUT or LINE INPUT).
When you select a source,
the power automatically
comes on.
Each time you press the
button, the source changes
as described on page 7.
AUX INPUT: To select the component
connected to the auxiliary input
jack on the control panel
LINE INPUT: To select the component
connected to the LINE IN plugs
on the rear
auxiliary input
MD player, etc.
CONTINUED ON THE NEXT PAGE
EN37-38.KD-SH99R[E]f 4/16/01, 9:22 AM37