Filter
Top Products
29
ENGLISH
3
Adjust the selected sound element.
• Refer to the table below for adjusting the
selected sound element.
4
Repeat steps 2 and 3 to adjust the
other sound elements.
5
Select one of the user sound modes
(USER 1, USER 2, USER 3).
6
Press EQ to store the adjustments.
To reset to the factory settings
Repeat the same procedure and reassign the
preset values listed in the table on page 45.
Storing your own sound
adjustments
You can adjust the sound modes to your preference
and store your own adjustments in memory
(USER 1, USER 2 and USER 3).
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Press EQ.
The last selected sound mode
is recalled, and is applied to
the current source.
2
Press SEL (select) to select sound
elements to adjust.
Each time you press the
button, the sound elements
change as follows:
LOW FREQ.* = LOW WIDTH = LOW LEVEL =
MID FREQ.* = MID WIDTH = MID LEVEL =
HIGH FREQ.* = HIGH LEVEL =
(back to the beginning)
FREQ. (LOW, MID, HIGH):
Select the center frequency to adjust.
WIDTH (LOW, MID):
Select the band width level (Q).
LEVEL (LOW, MID, HIGH):
Adjust the enhancement level.
* By pressing ¢ or 4, you
can directly move as follows:
Ex.: When you have selected “POP” previously
Ex.: When you select “USER 2”
Indication
WIDTH
LEVEL
FREQ.
LOW FREQ.
MID FREQ.
HIGH FREQ.
Preset values
LOW MID HIGH
50 Hz 700 Hz 8 kHz
80 Hz 1 kHz 12 kHz
120 Hz 2 kHz
1 (min.) 1 (min.)
||
4 (max.) 2 (max.)
–06 (min.) –06 (min.) –06 (min.)
|| |
+06 (max.) +06 (max.) +06 (max.)
EN27-29.KD-SH99R[E]f 4/16/01, 9:20 AM29