Filter
Top Products
11
Adjusting the Tone (Bass/Treble)
You can adjust the bass level (low frequency range)
and the treble level (high frequency range) within a
range of –5 to +5.
When shipped, the bass level set to “BASS 0” and the
treble level set to “TREBLE +1.”
• This function only affects the playback sound, and
does not affect your recording.
• There is a time limit in doing the following steps. If
the setting is canceled before you finish, start over
from step
1
.
On the remote control ONLY:
1
Press BASS to adjust the bass level or
press TREBLE to adjust the treble
level.
2
Press UP to increase the
level or press
DOWN to
decrease it.
Reinforcing the Bass Sound
You can reinforce the bass sound to maintain rich, full
bass at low volume—Active Hyper Bass Pro.
• This function only affects the playback sound, and
does not affect your recording.
To get the effect, press AHB PRO so
that the
BASS
indicator lights up on the
display.
• Each time you press the button, the
bass reinforcement alternates between on (AHB ON)
and off (AHB OFF).
To cancel the effect, press AHB PRO again so that the
BASS
indicator goes off.
Turning On the Power
To turn on the unit, press
STANDBY/ON
( on the unit).
The STANDBY lamp on the unit goes off.
• When you press the source button
—3/8 CD, 2 3 TAPE, TUNER (or
BAND TUNER on the unit) and AUX, the unit
automatically turns on and starts playback if the
source is ready.
To turn off the unit (standby), press
STANDBY/ON ( on the unit) again.
The STANDBY lamp on the unit lights on.
• The CLOCK indicator and “0:00” flash on the
display until you set the built-in clock. After setting
the clock, the clock time will appear on the display
while the unit is on standby.
• A little power is always consumed even while the
unit is on standby.
To switch off the power supply completely, unplug
the power cord.
When you unplug the power cord or if a power
failure occurs
The clock is reset to “0:00” right away, while the tuner preset
stations (see page 12) will be erased in a few days.
Adjusting the Volume
You can adjust the volume level only while the unit is
turned on. The volume level can be adjusted between
“VOL MIN” and “VOLUME 1” – “VOLUME 40
(VOL MAX).”
Press VOLUME + to increase the
volume or press VOLUME – to
decrease it.
For private listening
Connect headphones to the PHONES jack. No sound comes
out of the speakers. Be sure to turn down the volume before
connecting or putting on headphones.
DO NOT turn the unit off (standby) with the
volume set to an extremely high level;
otherwise, the sudden blast of sound can
damage your hearing, speakers and/or
headphones when you turn on the unit or
start playing any source next time.
REMEMBER you cannot adjust the volume
level while the unit is on standby.
VOLUME
BASS
TREBLE
UP
DOWN
AHB PROAHB PRO
STANDBY/ON
EN01-15_UX-H30[B]f.pm6 02.12.26, 1:36 PM11