JVC CA-MXS5RMD Stereo System User Manual


 
– 59 –
Troubleshooting
Symptom
No sound is heard.
Unable to record on an MD.
Poor radio reception.
Unable to operate the remote control.
Loaded CDs and MD cannot be
ejected.
The CD does not play.
The CD skips.
If “AUX DIGITAL UNLOCK” appears
in the main display.
If “CAUTION!” appears in the main
display.
Operations are disabled.
Possible Cause
Connections are incorrect, or loose.
You are using a prerecorded MD.
The MD is write-protected.
The antenna is not connected
correctly.
The AM loop antenna is too close
to the unit.
The FM antenna is not properly
extended and positioned.
The path between the remote
control and the remote sensor on
the unit is blocked.
The batteries have lost their charge.
The main AC power cord is not
plugged in.
The Disc Lock function is in use.
The CD is upside down.
The CD is dirty or scratched.
There is no digital device connected to
the AUX terminal.
Something is wrong with your unit.
The built-in microprocessor has
malfunctioned due to external electrical
interference.
Action
Check all connections and make
corrections. (See pages 6 – 9.)
Change it with a recordable MD.
Unprotect the MD. (See page 33.)
Reconnect the antenna securely.
Change the position and direction of
the AM loop antenna.
Extend FM antenna to the best
reception position.
Remove the obstruction.
Replace the batteries. (See page 9.)
Plug in the AC power plug.
Turn off the Disc Lock function.
(See page 31.)
Put the CD in with the label side up.
Clean or replace the CD. (See page 55.)
Connect a digital device using digital
optical cord. (See page 8.)
Unplug the unit immediately, then
consult your dealer.
Unplug the unit then plug it back in.
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
When you turn on the unit in the POWER
SAVING mode
A mechanical noise will be heard from the MD recorder section.
This is a startup noise of power supply to the MD mechanism,
not a malfunction of the unit.
EN55-60.CA-MXS5RMD[B]/f 99.9.14, 1:55 AM59