– 34 –
Recording Any Sound Source — Standard
Recording
The following recording method can be applied to any
sound source.
1
Insert a recordable MD in the MD loading slot.
2
Select the source.
•
When recording a CD:
Press CD 1, CD 2, or CD 3 to select a disc you want
to record from, then 7.
•
When recording an FM/AM (MW/LW) broadcast:
Press FM/AM, then tune into a station you want.
When the source for recording is FM or AM (MW/LW),
you can select one of the two recording methods —
Stereo Recording and Monaural Recording. (See page 36
for more details.)
• When recording from external equipment:
Press TAPE/AUX to select it as the playback source.
When the source for recording is “TAPE,” you can select
the sound input level. See “To select the sound input
level” to the right.
3
Press REC PAUSE on the unit (or MD REC PAUSE
on the remote control).
The recording lamp on the unit starts flashing.
4
Press MD # / 8.
The recording lamp stops flashing and remains lit, and
recording starts.
•
When recording an FM/AM (MW/LW) broadcast:
The station frequency will be recorded as the track
title.
5
When recording a CD:
Press CD # / 8.
When recording from external equipment:
Start playback.
• For details, see the manual supplied with your
equipment.
To stop recording for a moment, press REC PAUSE (or
MD REC PAUSE) again.
To resume recording, press MD # / 8 again.
To stop recording, press 7. “WRITING” appears for a
while.
• When recording from a CD, both the CD player and the
MD recorder stop.
You can use more useful and easier recording
methods
• For recording from CDs, “Recording CDs” on page 35.
• For recording FM/AM broadcasts, “Recording FM/AM (MW/
LW) Broadcasts — Monaural Recording and Stereo Recording”
on page 36.
• For recording from the external equipment, “Recording the
External Equipment — Sound Synchronized Recording and
Stereo Recording” on page 36.
To select the sound input level
This is only used for recording from an analog source (ex.
tape or VCR) connected to the TAPE jacks on the rear.
If the recorded sound from such an analog source is not
loud enough, or if it is distorted, select the appropriate
sound input level before recording.
On the unit ONLY:
1
While “TAPE” is selected as the source to play,
press and hold PLAY/REC MODE until “TAPE
INPUT” appears in the main display.
2
Push the joy control upward (¡ ) or downward
(1
) to select the recording input level, then
press SET.
• “Level 1”: Select when the recorded sound is
distorted. This setting reduces the input
signal level. (Initial setting when shipped
from the factory)
• “Level 2”: Select when the recorded sound is not
loud enough. This setting increases the
input signal level.
Continued
EN32-37.CA-MXS5RMD[B]/f 99.9.14, 1:53 AM34