Filter
Top Products
– 48 –
5
Press CHARACTER to select the character set you
want.
• Each time you press the button, the character sets
change as follows:
6
Input a character.
1) Press the character entry button for a character
you want to input.
Examples:
• To input an “A” or “a,” press ABC once.
To input a “B” or “b,” press ABC twice.
To input a “C” or “c,” press ABC three times.
• To input a symbol, press MARK repeatedly until
the mark you want appears.
• To input a numeral, press 0 – 9.
• To move the character entry position while
entering a title, press ø (10) or Ø (+10).
• If you have entered an incorrect character, press
CANCEL to cancel the last entry.
2) Press the button for the next character you want
to input.
• If the next character you want to input is assigned
to the same button you have just pressed in step
6-
1), press Ø (+10) first to move the character
entry position to the right.
7
Repeat steps 5 and 6 to enter other characters.
• The main display can only show 8 characters at a
time. If you enter the 9th character, the first character
disappears, and so on.
4
Press SET to enter the selected title entry mode.
8
Press ENTER to finish the current title entry.
“EDITING” appears for a while, then the unit enters
title entry mode again.
• You can assign another title by repeating steps 3 to 8.
9
Press MD TITLE (or ENTER again) to finish the
title entry.
10
Press 0 for the MD recorder to eject the MD.
“WRITING” appears while the editing you have
made is being recorded on the MD.
You can assign titles during play or recording
• During play:
Entering a track title
The MD recorder repeats playback of the current track until
you press ENTER in step 8 above. When you press ENTER,
the next track will be played.
Entering a disc title
The MD recorder repeats playback of all tracks of the MD until
you press ENTER in step 8 above. When you press ENTER,
the MD recorder enters the track title entry mode.
• During recording:
Entering a track title
The MD recorder continues recording even after you press
ENTER in step 8 above. When you press ENTER, a track title
is assigned to the track where you have started the title entry.
• During CD Synchronized Recording and the First Track
Recording:
You can assign the disc title, and 15 track titles one after
another as recording goes on. The track titles you have entered
are automatically assigned to the tracks recorded on the MD in
sequential order. If you enter 16th track title or more, they are
ignored.
If “NO OPERATION!” appears
You have tried to use the buttons on the unit while entering a title
using the remote control. Use the remote control only.
Available Symbols are as follows:
(Blank)
Continued
Capital letters Small letters
Numerals
Character entry position
EN44-49.CA-MXS5RMD[B]/f 99.9.14, 1:54 AM48