JVC CA-MXJ777V Stereo System User Manual


 
27
English
6
When selecting “– CD – – –”.
1) Press 4 ; or ¢ ; to select the disc
number, then press SET k.
2) Press 4 ; or ¢ ; to set the track number,
then press SET k.
The unit enters volume setting mode.
When selecting “TUNER FM” or “TUNER AM”
Press 4 ; or ¢ ; to select the preset station number, then
press SET k.
The unit enters volume setting mode.
7
Press 4 ; or ¢ ; to set the
volume level.
You can select the volume level from among
four levels. If you select “ VOL – – –,” the vol-
ume is set to the last level when the unit has been turned off.
PRESET
PREV
NEXT
DAILY
SET
SEA CONTROL
STANDBY
TIMER
/CLOCK
CANCEL
DEMO
SET
SEA CONTROL
Using Recording Timer
With Recording Timer, you can make a tape of a radio broadcast
automatically.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified station,
sets the volume level to “0,” and starts recording when the on-time
comes (the b indicator flashes just before the on-time, and continues
flashing while the timer is operating). Then, when the off-time comes
(“OFF” appears just before the off-time), the unit automatically turns
off (stands by).
The timer setting remains in memory until you change it.
There is a time limit in doing the following steps. If the setting is
cancelled before you finish, start from step 1 again.
If you have made a mistake while setting the timer, press CANCEL
/. (However, this does not always work. If CANCEL does not
work, press TIMER/CLOCK h repeatedly and start from step 1
again.)
On the unit On the unit
ONLY
::
1
Put a recordable cassette into deck B.
2
Press TIMER/CLOCK h until “REC”
appears on the display.
The REC indicator also starts flashing on the display.
TIMER
/CLOCK
REC
Each time you press the button, the timer setting modes change
as follows:
DAILY
Cancelled
ON TIME
ON TIME
REC
Clock
setting
(See page 7.)
TIMER
/CLOCK
3
Press TIMER/CLOCK h again.
“ON TIME” appears for 2 seconds, then the unit
enters on-time setting mode.
REC
REC
8
Press SET k to complete the Daily Timer
setting.
The DAILY indicator stops flashing and remains lit.
The setting you have done are shown on the display in sequence.
9
Press 2 , @to turn off the unit
(on standby) if you have set the Daily
Timer with the unit turned on.
To turn on or off Daily Timer after its setting is done
1. Press TIMER/CLOCK h repeatedly until "DAILY"
appears on the display.
2. To turn off the Daily Timer, press CANCEL /.
The DAILY indicator goes off from the display.
The Daily Timer is cancelled, but the setting for the
Daily Timer remains in memory.
To turn on the Daily Timer, press SET k.
The DAILY indicator lights up on the display.
The setting you have done are shown on the display in
sequence for your confirmation.
If the unit is turned on when the timer-on timer
come
Daily Timer does not work.
Continued
PRESET
PREV
NEXT
SET
SEA CONTROL
EN26-33;MX-J777V/PM6 7/8/99, 9:15 AM27