JVC CA-MXGT700 Stereo System User Manual


 
25
English
Maintenance
To get the best performance of the unit, keep your discs, tapes, and mechanism clean.
Handling cassette tapes
If the tape is loose in its cassette, take up
the slack by inserting a pencil in one of
the reels and rotating.
If the tape is loose, it may get stretched,
cut, or caught in the cassette.
Be careful not to touch the tape surface.
Avoid the following places to store the
tape:
In dusty places
In direct sunlight or heat
In moist areas
Near a magnet
Handling discs
Remove the disc from its case by
holding it at the edge while pressing the
center hole lightly.
Do not touch the shiny surface of the
disc, or bend the disc.
Put the disc back in its case after use to
prevent warping.
Be careful not to scratch the surface of
the disc when placing it back in its case.
Avoid exposure to direct sunlight,
temperature extremes, and moisture.
To clean the disc
Wipe the disc with a soft cloth in a straight
line from center to edge.
DO NOT use any solventsuch as
conventional record cleaner, spray, thinner, or
benzineto clean the disc.
Cleaning the unit
Stains on the unit
Should be wiped off with a soft cloth. If the unit is heavily
stained, wipe it with a cloth soaked in water-diluted neutral
detergent and wrung well, then wipe clean with a dry cloth.
Avoid the following since they may cause damage to the
unit.
- DO NOT wipe it with a hard cloth.
- DO NOT wipe it strong.
- DO NOT wipe it with thinner or benzine.
- DO NOT apply any volatile substance such as
insecticides to it.
- DO NOT allow any rubber or plastic to remain in
contact with it for a long time.
19-28.MXGT700&G500[UW]8.pm6 02.5.23, 3:48 PM25