Filter
Top Products
– 9 –
English
Canceling the Display Demonstration
When connecting the AC power cord into a wall outlet, the
unit automatically starts display demonstration.
On the unit ONLY:
To cancel the display demonstration, press
CANCEL/DEMO.
When you press other buttons
The display demonstration stops temporarily. It will start
automatically again (if no operation is done for 2 minutes) until you
cancel it by pressing CANCEL/DEMO.
To start the display demonstration manually
Press and hold CANCEL/DEMO again for more
than 2 seconds.
CANCEL
/
DEMO
CANCEL
/
DEMO
Adjusting the Voltage Selector
Before plugging in the unit, set the correct voltage for your
area with the voltage selector on the rear of the unit.
Use a screwdriver to rotate the voltage selector so the voltage
number the voltage mark is pointing at is the same as the
voltage where you are plugging in the unit. (See the back
cover page.)
DO NOT plug in before setting the voltage selector
on the rear of the unit and all connection
procedures are complete.
NOW, you can plug in the unit and other
connected equipment FINALLY!
220
12
7
24
0
110
230-
AUX
IN
VOLTAGE
SETTING
VOLTAGE
SETTING
220
127
110
230-
240
MAIN SPEAKER
SUBWOOFER
[ ]
RR
LL
[ ]
4-8
6-16
01-13.MXGT700&G500[UW]8.pm6 02.5.23, 3:46 PM9