Filter
Top Products
– 23 –
English
6
Select the preset station
number.
Press 4 or ¢ to select the preset
station number, then press SET.
The unit enters volume setting mode.
7
Press 4 or ¢ to set the volume
level.
• You can select the volume level from VOL
MIN, VOL 1 — VOL 30, and VOL MAX.
8
Press SET to complete the Daily
Timer setting.
The DAILY (daily timer) indicator stops
flashing and remains lit. The settings you have
done are shown on the display in sequence for your
confirmation.
9
Press STANDBY/ON to
turn off the unit (on standby)
if you have set the Daily Timer
with the unit turned on.
If the unit is turned on when the timer-on time comes
Daily Timer does not work.
To turn on or off Daily Timer after its setting is done
1
Press CLOCK/TIMER repeatedly until
“DAILY” appears on the display.
2
To turn off the Daily Timer, press
CANCEL/DEMO.
The DAILY (daily timer) indicator goes off
from the display (“OFF” appears for a while).
The Daily Timer is canceled, but the setting
for the Daily Timer remains in memory until
you change it.
To turn on the Daily Timer, press SET.
The DAILY (daily timer) indicator lights up
on the display. The settings you have done are
shown on the display in sequence for your
confirmation.
Using Recording Timer
With Recording Timer, you can make a tape of a radio
broadcast automatically. You can set the timer whether the
unit is on or off.
How Recording Timer actually works
The unit automatically turns on, tunes into the specified
station, sets the volume level to “VOL MIN,” and starts
recording when the on-time comes (the indicator flashes
while the timer is operating). Then, when the off-time comes,
the unit automatically turns off (stands by).
Recording Timer works only once, but the timer setting
remains in memory until you change it.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step
2
again.
• If you have made a mistake while setting the timer, press
CANCEL/DEMO. (However, this does not always work. If
CANCEL/DEMO does not work, press CLOCK/TIMER
repeatedly and start from step
2
again.)
On the unit ONLY:
1
Put a recordable cassette into deck B.
2
Press CLOCK/TIMER repeatedly
until “REC” appears on the display.
indicator lights up and the REC (recording
timer) indicator starts flashing on the display.
• Each time you press the button, the clock/timer setting
modes change as follows:
3
Press CLOCK/TIMER again.
“ON TIME” appears for 2 seconds, then the unit
enters on-time setting mode.
DAILY
Canceled
ON TIME
(Recording Timer)
CLOCK
(See page 10.)
RECON TIME
(Daily Timer)
SET
SET
CLOCK
/
TIMER
CANCEL
/
DEMO
SET
CLOCK
/
TIMER
CLOCK
/
TIMER
STANDBY/ON
STANDBY
19-28.MXGT700&G500[UW]8.pm6 02.5.23, 3:47 PM23