Filter
Top Products
– 13 –
English
On the unit ONLY:
1
Tune in the station you want to preset (in this
example, of FM 87.50).
• See “Tuning in a Station.”
2
Press SET.
3
Press PRESET + or PRESET – to
select a preset number.
4
Press SET again.
The tuned station in step
1
is stored in the preset number
selected in step
3
.
• Storing a new station on a used number erases the
previously stored one.
When you unplug the AC power cord or if a power
failure occurs
The preset stations will be erased in a few days. If this happens,
preset the stations again.
Tuning in a Preset Station
1
Press FM/AM.
The unit automatically turns on and tunes
in the previously tuned station (either FM
or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Select a preset number.
On the unit:
Press PRESET + or PRESET –.
On the remote control:
Press the number buttons.
Ex.: For preset number 5, press 5.
For preset number 15, press +10
then 5.
For preset number 20, press +10,
then 10.
For preset number 25, press +10,
+10, then 5.
For preset number 30, press +10, +10, then 10.
Listening to the Radio
Before operating the tuner, make sure you have selected
the correct AM Tuner interval spacing (see page 11).
Tuning in a Station
1
Press FM/AM.
The unit automatically turns on and tunes
in the previously tuned station (either FM
or AM).
• Each time you press the button, the band
alternates between FM and AM.
2
Start searching for stations.
On the unit:
Press and hold TUNING + or
TUNING – for more than 1
second.
On the remote control:
Press and hold 4/1 or
¢/¡ for more than 1 second.
The unit starts searching for stations and
stops when a station of sufficient signal
strength is tuned in.
If a program is broadcast in stereo, the ST
(stereo) indicator lights up.
To stop during searching, press TUNING + or TUNING –
(or 4/1 or ¢/¡ on the remote control).
When you press TUNING + or TUNING –
(or 4/1 or ¢/¡ on the remote control) briefly
and repeatedly
The frequency changes step by step.
To change the FM reception mode
When an FM stereo broadcast is hard to receive or
noisy, press FM MODE on the remote control so
that “MONO” appears and the MONO indicator
also lights up on the display. Reception improves.
To restore the stereo effect, press FM MODE again so that
“STEREO” appears on the display.
In this stereo mode, you can hear stereo sounds when a
program is broadcast in stereo.
Presetting Stations
You can preset 30 FM and 15 AM stations.
In some cases, test frequencies have been already memorized
for the tuner since the factory examined the tuner preset
function before shipment. This is not a malfunction. You can
preset the stations you want into memory by following the
presetting method.
• There is a time limit in doing the following steps. If the
setting is canceled before you finish, start from step
2
again.
FM MODE
SET
12
3
4
5
6
78
9
10
+10
SET
FM
/AM
FM
/AM
VOLUME
VOLUME
+
–
01-13.MXGT700&G500[UW]8.pm6 02.5.23, 3:46 PM13