Filter
Top Products
15
English
• To stop recording temporarily, press REC PAUSE
button or 6 (play/pause) button on the MD recorder
or MD 6 (play/pause) button on the remote control.
• To resume recording, press 6 (play/pause) button
on the MD recorder or MD 6 (play/pause) button
on the remote control again.
Each time you press DISPLAY/CHARA. button,
information switches between the remaining time for
the recording and the elapsed time with the track
number of the MD alternately.
6
Press 7 (stop) buttons both on the MD recorder and
the cassette deck to quit recording as required.
“WRITING” appears in the display window, and you
can remove the MD and the tape by pressing 0 (eject)
buttons.
Using
77
77
7 (stop) button on the remote control, you
cannot stop both the MD recorder and the
cassette deck. Make sure to press each button on
both units.
Recording a Tape — Sound Synchronized Recording
Setting the recording mode, you can start playing back a
tape and recording it onto an MD simultaneously.
1
Repeat the steps 1 and 2 in the previous section on
this page.
2
Press REC MODE button behind the sliding panel
to select a recording mode as follows:
3
Press SET button.
REC indicator on the MD recorder lights red, and
information appears in the display window as follows:
Recording a Tape
When recording from TD-UXG6 cassette deck, you can
select one of the two recording methods — Manual
Recording (stereo) and Sound Synchronized Recording.
• Manual Recording — Sound is recorded in stereo (both
on the left and right audio channels). You have to operate
the MD recorder and the cassette deck respectively.
• Sound Synchronized Recording — With this method, you
can start recording when the sound signals come into the
MD recorder (sound is recorded in stereo).
Sound Synchronized Recording will stop automatically
if no sound comes in for more than 30 seconds.
If Sound Synchronized Recording will not work
correctly
Use the Manual Recording. Sound Synchronized
Recording starts automatically when the MD recorder
detects sound signals come in. If sound signal is too
weak for this unit to detect, Sound Synchronized
Recording will not start (or will stop even while the
source is being played).
Recording a Tape Manually
1
Insert a recordable MD into the MD loading slot.
The MD IN lamp lights orange.
2
Prepare a tape playback.
• Place a tape on the tape tray, press ` (playback)
button on the cassette deck or TAPE ` (playback)
button on the remote control, then press 7 (stop)
button before going to the next step.
3
Press REC PAUSE button on the MD recorder.
The REC indicator on the MD recorder lights red, and
the MD recorder switches to the recording-pause mode.
4
Press 6 (play/pause) button on the MD recorder
or MD 6 (play/pause) button on the remote
control.
The MD recorder starts recording, and information
changes in the display window and the remaining time
for recording appears as follows:
5
Press ` (playback) button on the cassette deck or
TAPE ` (playback) button on the remote control
in succession.
Continued
EN11-18.XM-G6[J]/2b 99.12.09, 17:5815