JBL CVSUB50 Home Theater System User Manual


 
7
Important Safety Note:
The customer is solely
responsible for proper selec-
tion of mounting hardware
not included with the speak-
ers, and for proper assembly
and installation of the wall
brackets, including but not
limited to the selection of
appropriate weight-bearing
supports and proper use of
the bracket. JBL disclaims
any liability for the selection
of mounting hardware
and/or bracket installation.
Be sure to follow these
bracket assembly and instal-
lation instructions carefully.
If you have any questions or
doubts about your ability to
correctly wall-mount the
speakers, consult with your
authorized JBL dealer or
custom installer.
Prepare the speaker wire as
described on page 8, keeping
the (+) conductor to the left
and the (–) conductor to the
right as you face the wall.
Mount the
attachment
plate into a
wood stud
on the wall,
using three
#10 pan-
head wood
screws at
least one
inch long
(not sup-
plied).
Make sure
that all three screws are
driven into the stud and not
into drywall. If the bracket
needs to be mounted in dry-
wall, the customer is respon-
sible for selecting and using
appropriate wall anchors and
screws.
Making sure to
preserve the
proper polarity
(+ and –
connec-
tions), use the
supplied
termi-
nal
wrench to loosen the red col-
lar of the binding post until
the pass-through hole under-
neath it is revealed. Insert the
bare end of the positive wire
through the hole, then screw
the collar down until it is tight.
Follow the same procedure to
connect the negative wire to
its terminal.
Carefully lower the speaker
onto the bracket so that the
mounting bracket
on the satellite
slides over the
wall attachment
plate until the
metal spring
clip engages
in the square
hole in the
plate.
††
Shown without
speaker attached to bolts.
WALL-MOUNTING
ATTACHING THE CRADLE TO THE CENTER SPEAKER
Important Safety Notes:
The CVCEN50 cradle is only
intended for use with the
CVCEN50 speaker. Attempting
to use the cradle with any
other model speaker is
unsafe and may result in
personal injury and damage
to the equipment.
The cradle must be placed
in a safe location, protected
from young children and
pets who might topple it,
possibly resulting in serious
injury. Never place the cra-
dle so that any part of it is
sticking out over the edge
of the table, shelf or other
surface underneath it.
If you intend to install the
CVCEN50 speaker on top
of the JBL Cinema Vision
plasma television,
do not
use the cradle. Instead,
place it on the plasma
screen’s table stand, or,
if the screen is mounted
on the wall, mount the
CVCEN50 on the wall
above or below the screen.
Lower the CVCEN50 speaker
onto the cradle so that it
rests in the curved pedestal.
The metal clip should fit over
the tab at the top of the cradle.
††
CV OM 6/15/04 4:06 PM Page 7