iSymphony M1 Stereo System User Manual


 
17
1.) Press the STANDBY/ON button to turn the system ‘On’.
The display lighting comes on and the display
briefly shows HELLO”.
2.) Press the FUNCTION button to select the Tuner function.
An AM or FM frequency will appear on the
display.
Press the TUNER/BAND button again to
switch between the AM and FM bands if
necessary.
3.) Tune to the desired station as follows:
Manual Tuning
Repeatedly press the SKIP/TUNING + or buttons until the display shows the
exact frequency of the desired station. Use the Manual Tuning method to tune
to weak or distant stations that are not strong enough to be recognized by the
Automatic Tuning system.
Automatic Tuning
Depress and hold the SKIP/TUNING + or buttons until the display begins to
move, then release the buttons. The Tuner will search up or down the band for
the next strong signal and stop on that station. Repeat this procedure until the
tuner stops on your desired station.
4.) If you tuned to an FM Stereo station the ST
indicator will appear in the display. If the FM
Stereo reception is noisy or weak, press the
ID3/FM ST./ESP button on the remote
control to select the FM Mono mode.
5.) Adjust the VOLUME, DBBS and EQ controls to the desired settings.
6.) When you are finished listening press the STANDBY/ON button to return the
system to the Standby (Off) mode.
The display lighting goes off and the display changes from radio frequency to
correct time.
RADIO OPERATION