Integra DTR-80.2/70.2 Stereo Receiver User Manual


 
3
Updating the Firmware via Network
DTR-70.2, DTR-80.2 and DHC-80.2 allow you to update
firmware using network connection on rear panel.
*
In this procedure, on-screen display may vary
depending on the model.
Make sure the AV receiver/controller and TV are
turned on and Ethernet cable is connected to rear
panel of the AV receiver/controller.
Never unplug or turn off the AV receiver/controller
during updating process.
Never plug or unplug an HDMI cable and Ethernet
cable during updating process.
Never unplug the AC power cord during updating
process.
Do not access the AV receiver/controller from PC
during updating process.
It will take about 30 minutes to update the
firmware.
The AV receiver/controller will retain all your
settings after update is finished.
Before you start
Check HDMI Control (RIHD) setting. The update
may not be successful if this setting is on.
Turn off the controller device connected via
RS232C and via Ethernet network.
Turn off Zone 2 and Zone 3.
Stop playback of content from Internet radio, iPod,
USB or servers, etc.
How to turn off RIHD
1
In the Main menu select “ Hardware
Setup”.
2
Select “ HDMI”.
3
Set “ HDMI Control(RIHD)” to “Off”.