Filter
Top Products
85
Controlling Other Components
—Continued
Remote Control Codes for Integra
Components Connected via
Integra components that are connected via are con-
trolled by pointing the remote controller at the AV
receiver, not the component. This allows you to control
components that are out of view, in a rack, for example.
If you want to control an Integra component by pointing
the remote controller directly at it, or you want to control
an Integra component that’s not connected via , use
the following remote control codes:
•[DVD] Remote Mode button
5001:
Integra DVD player without (default)
• [CD] Remote Mode button
6001:
Integra CD player without (default)
• [MD] Remote Mode button
6007:
Integra MD recorder without
• [CDR] Remote Mode button
6005:
Integra CD recorder without
Note:
If you connect an -capable Integra MiniDisc or CD
recorder to the TAPE IN/OUT jacks, for remote opera-
tion to work properly, you must set the input display to
MD or CDR (see page 44).
Resetting the Remote Mode Buttons
You can reset a Remote Mode button to its default
remote control code.
You can reset the remote controller to its default settings.
1
Make sure the Integra component is con-
nected with an cable and an analog
audio cable (RCA).
See page 33 for details.
2
Enter the appropriate remote control code
for the Remote Mode button.
•[DVD] Remote Mode button
5002:
Integra DVD player with
• [CD] Remote Mode button
6002:
Integra CD player with
• [MD] Remote Mode button
6008:
Integra MD recorder with
• [CDR] Remote Mode button
6006:
Integra CD recorder with
See the previous page for how to enter remote
control codes.
3
Press the Remote Mode button, point the
remote controller at the AV receiver, and
operate the component.
1
While holding down the Remote
Mode button that you want to
reset, press the TV [ ] button.
The Remote indicator flashes three
times.
2
Press the Remote Mode button
again.
The Remote indicator flashes twice,
indicating that the button has been
reset.
The [DVD] and [CD] Remote Mode
buttons are preprogrammed with
remote control codes for controlling
Integra DVD players and CD players
respectively. When these buttons are
reset, the preprogrammed code is
restored.
Resetting the Remote Controller
1
While holding down the
[Receiver] Remote Mode button,
press the [Standby] button.
The Remote indicator flashes five
times.
2
Press the [Receiver] Remote
Mode button again.
The Remote indicator flashes twice,
indicating that the remote controller
has been reset.