Filter
Top Products
10
+ OUTPUT – (Speaker output and binding post)
The DTA-9.4 is equipped with high-current binding posts for use at
output terminals to the speaker system. To obtain the best in sound
quality from the DTA-9.4, we recommend the use of high-quality
speaker cables.
For each channel, connect the negative (white) output post to the
negative input terminal of the speaker and the positive (red) output
post to the positive input terminal of the speaker.
12V TRIGGER IN (CONTROL LINK IN)
Connects to the 12V trigger output terminal on the other device to
control the DTA-9.4.
Connecting to the Integra DTC-9.4 AV controller:
Use the attached stereo mini-plug cable to connect to the 12V
TRIGGER OUT terminal on the DTC-9.4.
Connecting to the 12V TRIGGER OUT B (CONTROL
LINK OUT) terminal:
This enables the DTA-9.4 to turn on or go into standby state
based on the power on/standby status of the DTC-9.4. The
brightness of the On or Standby indicator on the DTA-9.4 also
switches automatically in 4 levels according to the dimmer
setting (brightness adjustment of the display) of the DTC-9.4.
Connecting to the 12V TRIGGER OUT A terminal:
This enables the DTA-9.4 to turn on or go into standby state
based on the power on/standby status of the DTC-9.4.
Note:
Be sure to use the attached stereo mini-plug cable for connecting to
the DTC-9.4. Using any other cables does not allow control of the
DTA-9.4 with the Dimmer function to work.
Connecting to any other devices than the DTC-9.4:
Use the commercial 1/8-inch mono cable to connect to the 12V
trigger output terminal on the other device. This enables the DTA-
9.4 to turn on or go into standby state based on the power on/standby
status of other devices.
The tip polarity of the connectors are as shown below.
Rear panel facilities and connections
5-12 volts,
positive tip
polarity
AC INLET
Plug the supplied Power cord into this AC INLET and then into the
Power outlet on the wall.
• Do not plug the DTA-9.4 into the AC outlet other than an AC
wall socket. Avoid using the AC OUTLET of the control
amplifier as power supply outlet for the DTA-9.4.
• Do not use a Power cord other than the one supplied with the
DTA-9.4. The Power cord supplied is designed for use with the
DTA-9.4 and should not be used with any other device.
• Never have the Power cord disconnected from the DTA-9.4
while the other end is plugged into the wall outlet. Doing so may
cause an electric shock. Always connect by plugging into the
wall outlet last and disconnect by unplugging from the wall
outlet first.
• Before you plug in the DTA-9.4, confirm that all connections
have been made properly.
• Turning on the power may cause a momentary power surge,
which might interfere with other electrical equipment on the
same circuit, such as computers. If this happens, use a wall outlet
on a different circuit.
Power cord
(supplied)
To an AC wall outlet