Filter
Top Products
11
Insignia NS-CL1112 Clock Radio with iPod Dock
www.insigniaproducts.com
Using your clock radio
Before using your clock radio, make sure all connections are good,
then plug the AC adapter into your clock radio and an AC power
outlet.
Turning your clock radio on and off
To turn on your clock radio:
1 Press STANDBY/ON. Your clock radio turns on.
2 Press SNOOZE/DIMMER to control the brightness of the LCD.
3 Press STANDBY/ON again to switch your clock radio to standby
mode.
Setting and using the alarm
To set the alarm:
1 Press and hold the ALARM1 or ALARM2 button for two seconds
.
The hour digits, the “ALARM 1” or “ALARM 2” flag, and the source
icon (BUZZER is the default) start to blink.
2 Turn the TUNING/SKIP knob to set the hour you want the alarm to
wake you.
3 Press the ALARM1 or ALARM2 button. The minute digits start to
blink.
4 Turn the TUNING/SKIP knob to set the minutes at which you want
the alarm to wake you.
5 Press the ALARM1 or ALARM2 button again, then turn the
TUNING/SKIP knob to select AL-H (alarm volume high) or AL-L
(alarm volume low).
6 Press ALARM1 or ALARM2 to store the setup.
7 Press the ALARM1 or ALARM2 button again. The ALARM turns
off.
8 Press the ALARM1 or ALARM2 button two times. The ALARM
turns on, then turns off.
Notes
• During alarm setting, if no button is pressed within 10
seconds, the system will exit alarm setting mode
automatically, without storing the settings.
• The Alarm1 default setting is 6:00, and the Alarm2
default setting is 7:30 (12H format only – the word "AM"
or "PM" is shown)
NS-CL1112_09-0459_MAN_ENG_V4.fm Page 11 Friday, June 5, 2009 2:44 PM