Filter
Top Products
10
Insignia NS-CL1112 Clock Radio with iPod Dock
www.insigniaproducts.com
3 Close the battery compartment cover.
Making connections
Connecting the AC adapter
Make sure that the AC power outlet matches the AC adapter’s power
specifications (100-240 V ~ 50-60 Hz) prior to plugging in the adapter.
To connect the AC adapter:
1 Plug the small DC power connector into the AC adapter jack on
the back of your clock radio.
2 Plug the AC adapter into an AC power outlet.
Setting the clock
To set the clock:
1 In standby mode, press and hold the CLK SET button on the top
of your clock radio for two seconds. The hour format (12 or 24) is
displayed on the LCD.
2 Turn the TUNING/SKIP knob to change the format between 12
and 24.
3 Press the CLK SET button again. The hour setting starts blinking.
4 Turn the TUNING/SKIP knob to change the hour setting.
5 Press the CLK SET button again. The minute setting starts
blinking.
6 Turn the TUNING/SKIP knob to change the minute setting, then
press the CLK SET button to store the setting.
Warnings
• Do not recharge, short, disassemble, or heat the
batteries, or dispose of in a fire.
• Dispose of battery in the proper manner, according to
federal, state, and local regulations.
• Remove the batteries when the charge is depleted.
• Battery chemicals can cause a rash. If the batteries leak,
clean the battery compartment with a cloth. If chemicals
touch your skin, wash immediately.
Note
If no button is pressed for ten seconds, the clock radio exits
clock setting mode without storing the setting.
The clock is displayed in standby mode. To view the clock in
radio mode, press and hold CLK SET for two seconds.
Press it again to return to the normal display.
NS-CL1112_09-0459_MAN_ENG_V4.fm Page 10 Friday, June 5, 2009 2:44 PM