Filter
Top Products
LISTENING WITH EARPHONES
Connect the plug of the stereo earphones into
the PHONES (GREEN) socket.
Caution: Avoid excessive volume level and lis-
tening to sound for a long period of time when
using earphones.
"Adjust volume to the desired level.
HANDLING COMPACT DISCS
This unit is
designed to play only
compact
discs
bearing the identification logo below.
Other discs may not conform to the CD
stan-
dard and may not play properly.
! Dirty, scratched or warped discs may cause
skipping or noise.
! Handle the disc only by the edges. To keep
clean, do not touch its surface.
! Discs should be stored in their cases after use
to avoid serious scratches.
! Do not expose disc to direct sunlight, high
humidity, high temperature, dust, etc. Pro-
longed exposure to extreme temperatures can
warp the disc.
! Do not stick or write anything on either side of
disc. Sharp writing instruments or the inks used
in some felt tip pens may damage its surface.
Remove the disc
Hold the edge and gently press the center pivot
as illustrated to pick up the disc.
CAUTION:
Wait for the disc to stop rotating before pressing the
OPEN button.
Note: This unit can play 3” (8cm) single CDs
without an adapter. Do not use a C
D single
adapter for these discs.
INSERT WITH
THE LABEL
FACING UP.
PRESS THE CLAWS
AT THE CENTER OF
THE DISC CASE.
PRESS THE
DISC GENTLY
TO INSERT IT.
LIFT OUT WITHOUT
TOUCHING THE
RECORDED SURFACE
INCORRECT
CORRECT
FROM THE CENTER TO THE EDGE
INCORRECT
CHANGING THE CORD ORIENTATION (Optional Type 1 or 2)
(Type 1)
1. Remove the two large flathead slot-
ted screws with a coin.
2. Gently remove plastic plate to ex-
pose the cord.
3. Gently lift the cord and reroute to
rear edge. Be sure to insert cord in
the appropriate restraining channel.
4. Reattach the plastic plate, reinsert
the two screws, and retighten screws.
(Type 2)
1. Gently pull out the plug that was origi-
nally plugged into the corner of
cassette.
2. Insert the plug into the jack perpen-
dicular to the jack which the plug was
removed.
3. If it is difficult to insert the plug into
the jack rotate the plug until it fits the
cassette corner properly.
LISTENING IN THE CAR
1. Plug the cord into the HEAD-
PHONES jack.
2. Insert the cassette adapter into
the deck’s cassette slot.
OR
Type 1
Type 2
76