Filter
Top Products
12
Shutting down the projector
Auto Off Time
The projector also has an Auto Off Time feature that automatically turns the
projector off after no active sources are detected and no user interaction with the
projector is performed for 30 minutes. By default, this feature is off. You can
change the length of time, see page 30.
Turning off the projector
To turn the projector off, press the Power button on the remote or keypad. The
lamp turns off and the Power LED blinks blue for 30 seconds while the fans
continue to run to cool the lamp. If the Power Saving Mode feature is on and when
the lamp has cooled, the LED lights blue and the fans stop. If the Power Saving
Mode feature is off and when the lamp has cooled, the LED blinks blue and the fans
stop. Unplug the power cable to completely power off the projector.
Troubleshooting your setup
If your image appears correctly on the screen, skip to the next section. If it does
not, troubleshoot the setup.
The Status Indicator Lights on top of the projector indicates the state of the
projec
tor and can help you troubleshoot
.
Table 6: Status Indicator Lights
Status Indicator Light Meaning
POWER: Solid Blue
TEMP: Off
LAMP: Off
POWER: Blinking Blue
TEMP: Off
LAMP: Off
1. If the Power Saving Mode feature is
on, the proje
ctor is plugged in.
2. The projector is on and initialized.
3. The projector is in normal operation.
1. If the Power Saving Mode is off, the
p
r
ojector is plugged in.
2. The projector is powering down and
the f
ans are cooling the projector.
POWER: Blinking blue
TEMP: Blinking red
LAMP: Blinking red
POWER: Solid blue
TEMP: Blinking red
LAMP: Blinking red
The projector fan(s) are not operating
correctly and the
projector has
been
shut down.
The lamp failed to ignite.
Contact Technical Support if the
problem persists. Vi
sit
www.infocus.com/support to contact
service.
POWER: Solid blue
TEMP: Blinking red
LAMP: Blinking red
The lamp has reached its end of life and
must be replaced.
The lamp will
continue to operate untils it fails.
Contact Technical Support. Repair may
be need
ed.
POWER: Solid blue
TEMP: Blinking
red
LAMP: Off
1. The projector is overheating and the
lam
p will be shut off. The fans will
continue to run.
2. The projector will not turn back on
until the co
oling process is complete.