Filter
Top Products
9
TSS-SAT4000
Step Six
The wall-bracket design allows for rotation of the speakers
at angles up to 30 degrees of center.Position the speakers
so they face toward the primary listening position,before
fully tightening.
Figure 3.This example shows how to connect bare wires to the
terminals.Banana plugs may also be inserted directly into the
r
ear of the connector.
ᕡ Loosen the terminals.
ᕢ Insert bare ends; tighten terminals.
CARE OF YOUR SPEAKER SYSTEM
When needed,use a soft cloth to remove any fingerprints or
to wipe off dust.Do not use any cleaning products or polished.
Clean the grille by gentle vacuuming.
– +
ᕡ
ᕢ
WIRING THE SPEAKER
After placing the speaker, you are ready to connect it to your
system.First,turn off all audio-system power. Use high-quality
speaker wire to make the connections.Consult the owner’s
manuals,included with your amplifier or receiver, for connection
and operation procedures.
Surround Modes
When using the TSS-SAT4000 in a Dolby* Digital or DTS
®
home
theater system,make sure the receiver’s/processor’s speaker
modes are set to “Small.”
Wiring and Polarity
The TSS-SAT4000 speaker has gold-plated terminals that
can accept bare wire.To ensure proper polarity, connect each
+ terminal on the back of the amplifier or receiver to the
respective + (red) terminal on each speaker, as shown in
Figure 3.Connect the – (black) terminals in a similar way.
See the owner’s manuals that were included with your amplifier
or receiver to confirm connection procedures.
Important!
Do not r
e
verse polarities (i.e.,+ to – or – to +) when making
connections.Doing so will degrade the imaging and bass
response of the home theater system.
After correctly placing and wiring the TSS-SAT4000 and
the r
est of your speaker system,adjust the levels for all of
the channels as r
ecommended by the manuf
actur
er of your
receiver/processor.
INFP1595Sat4000-OM 10/18/04 2:42 PM Page 9