Filter
Top Products
7
TSS-SAT4000
Step Four
For Medium and Large Table Stand Assembly
Use screw and washer to attach medium
or lar
ge base assembly to the
speaker assembly, as shown.
(3) 1/4-20 x 7/8"
Flat-Head Screws
(3) 1/4-20 x 7/8"
Flat-Head Scr
ews
1/4-20 x 1"
Pan-Head Screw
Flat Washer
Flat
Washers
1/4-20 x 1"
Pan-Head Screw
1/4-20 x 3/4"
Pan-Head Screw
Step Five
For Medium and Large Table Stand Assembly
Run speaker wire through table stand plate. Use three screws
(provided) to attach plate to bottom of base assembly.
Step Two
For Medium and Large Table Stand Assembly
Using the inc
luded Allen wrench,remove the bottom end cap
of the speaker by unscrewing the single center screw on bottom.
NOTE:The bottom is the
side closest to the Infinity
logo on the front grille
and the speaker
connections on the rear.
Satellite Speaker
Inf
inity Logo
End Cap
1/4-20 x 3/4"
Screw
Step Three
F
or Medium and Large Table Stand Assembly
Run speaker wire through collar. Using three screws,attach table
stand plate to the medium or large section as shown.
Speaker Wire
Speaker Wire
INFP1595Sat4000-OM 10/18/04 2:42 PM Page 7