Filter
Top Products
8
TSS-SAT4000
Wall-Mounting the SAT-4000 Using the Included
Wall Bracket
The customer is responsible for proper selection and use of
mounting hardware,and for correctly and safely wall-mounting
the speakers.
Step One
Remove the wall-bracket
co
ver by removing the four
wall bracket screws on
the ends as shown.
Step Two
Run the speaker wire behind the
wall bracket and out the hole at
the bottom.After deciding where
to place the satellite speaker,
attach the wall bracket (in a
vertical position) to the wall
using the appropriate screws
and anchors.
Step Three
Run the speaker wir
es out
thr
ough the bottom hole of the
wall bracket cover. Resecure
in place as shown with four
of the wall bracket screws.
Step Five
Connect the wires (page 9).
Replace the end caps while
capturing the wall bracket in
between parts A and B and
secur
ing it in place
.
T
ighten
until snug.
Mounting
Screws and
Anchor
s
Not Included
Wall-Mount
End Cap A
Wall Bracket
Bottom Hole
Wall-Mount
End Cap B
Step Four
Using the included Allen wrench,remove the bottom end cap
of the speaker by unscrewing the single center screw on bottom.
NOTE:The bottom is the
side closest to the Infinity
logo on the front grille
and the speaker
connections on the rear.
Satellite Speaker
Infinity Logo
End Cap
1/4-20 x 3/4"
Screw
End Cap
INFP1595Sat4000-OM 10/18/04 2:42 PM Page 8