Filter
Top Products
6
TSS-SAT4000
1/4-20 x 1-1/4"
Flat-Head Scr
ew
Step Three
For Small Table Stand Assembly
Assemble the table stand plate,the small section and the foot.
Place thr
ee nuts (provided) in base of foot and secure them
in place by three screws (provided) through the top of the
table stand plate.
Step Four
For Small Table Stand Assembly
Run speaker wire through base, and screw foot assembly to
speaker assembly.
(3) 1/4-20 Nuts
T
able Stand Plate
Speaker Wire
Small Section/Collar
Foot
(3) 1/4-20 x 7/8"
Flat-Head Screws
Step Two
F
or Small Table Stand Assembly
Using the included Allen wrench,remove the bottom end cap
of the speaker by unscrewing the single center screw on bottom.
NOTE:The bottom is the
side closest to the Infinity
logo on the front grille
and the speaker
connections on the rear.
Satellite Speaker
Infinity Logo
End Cap
1/4-20 x 3/4"
Screw
INFP1595Sat4000-OM 10/18/04 2:41 PM Page 6