Filter
Top Products
6
English
Getting Started
Master Power Switch
The iW3 has a master power switch that is used to power the unit ON or OFF, help conserve battery life, and reset the iW3 speaker. In order
for the iW3 speaker to power ON, the battery must be charged or placed on the charging base connected to an AC outlet.
Master Power ON - Slide the Master Power Switch (on rear panel) to the ON position to activate your iW3 speaker.
Master Power OFF - Slide the Master Power Switch to the OFF position to power the iW3 speaker OFF.
Note: If the iW3 is in the Master Power OFF state the iW3 will only allow charging of the iW3’s internal battery and will not support
iPod/iPhone charging, AirPlay, network setup, nor rmware updates.
Powering your iW3 speaker ON
To power the iW3 speaker ON:
1. Plug AC adaptor into Charging Base, and plug into a live AC wall outlet.
2. Place the iW3 Speaker on top of the Charging Base.
3. Slide the Master Power Switch (on rear panel) to the ON position.
Note: Allow 30 seconds for the speaker to startup before interacting with the iW3 speaker.
4. Press the Power button to switch between power ON and Standby mode.
The iW3 speaker will power ON to the previous mode (default is AirPlay mode).
o | on
power
12V
outlet
1 2 3
30s for startup
Rechargeable Battery
The iW3 speaker has an internal rechargeable battery and supports audio playback anywhere in the home when the battery is charged.
To Charge the Battery:
1. Plug AC adaptor into Charging Base, and plug into a live AC wall outlet.
2. Place iW3 Speaker on top of Charging Base.
Note: Allow up to 10 hours to fully charge the iW3’s battery
Resetting your iW3 speaker
It is possible for the iW3 speaker to lockup and be unresponsive, making it necessary to reset the unit.
To reset the iW3 speaker:
1. Remove the iW3 Speaker from the Charging Base.
2. Using a paper clip, press the Reset Button on the bottom of cabinet within the charging base recess.
The iW3 will reboot and power ON again.
network setuppower
o | on
o | on
power
Reset the iW3 speaker by using a
paper clip to press the reset button
Reset button