Filter
Top Products
Current Firmware Version : 00.0.0
13
English
Firmware update continued...
Option C - Firmware update using Mac/PC
Device Name
Networking
To update the firmware of this device, you must first visit
iHomeaudio.com/support and download the latest firmware for
this speaker.
Once you have the new firmware file, you can initiate the
firmware update process.
Note: If a file selection interface does not appear in approximately
30 seconds, you may try reloading this page using the reload
button on your web browser.
You can only complete firmware update using this page from a
PC or Mac.
Begin Update
Firmware
Model: iW3
Firmware: 08.0.0
MAC address: a3:4b:61:e5:24:22
For support and product information, visit
www.ihomeaudio.com/support
http://10.0.1.2
You can only complete
f
irmware update usin
g
this pa
g
e
f
rom a
PC
o
r Mac
.
100%25%
no LEDs
installation = 0% 50% 75%
Follow these steps to update the rmware of your iW3 speaker
using only your Mac or PC. Please note that we recommend trying
option A or B before attempting this method.
1. Using your computer visit:
www.ihomeaudio.com/support/product/iW3 and download
the latest rmware from the top right corner of the support
page. Please be sure to remember the location where you save
the le to on your computer.
2. Verify that your iW3 is successfully connected to your home
network.
3. Open a web browser (we recommend Safari) and access the
iHome Device Management webpage by using Bonjour
services or directly typing in the iW3’s IP address. The IP address
can be found using iHome Set under network details or by
re-initiating the network setup mode on page 10.
Note: Make sure that you have enabled Bonjour service in your
PC. Take Windows XP for example: to enable the service, you can
click Start->Settings->Control Panel, and double click Adminis-
trative Tools-> Services->Bonjour Service, then click Start
followed by OK on the pop-up menu.
4. If everything was done correctly you'll see the page pictured.
5. Click the "Firmware" tab on the left column and follow the
on-screen instructions.
During Firmware Update:
1. The top panel LED's will light up in succession to note the progress of the update (see diagram below)
2. The iW3’s device management web page will indicate progress.
The iW3 will restart if rmware update is successful.
Note: This process can take 4-5 minutes.